1999 Dodge Intrepid 2.7 won't start from key. Will start if you bump the starter, but won't disengage. Starter just keeps running. When I first started having problems for 2 days it would click on first couple tries and then start. On day 3 it would click or start. Figured it was the starter and bought a reman. Now its not making the clicking noise. But only starts from bumping the starter. Check the battery and relays all seem fine. What could the problem be.

SOURCE: THERMOSTAT PICTUREDIAGRAM OF 1999 DODGE INTREPID, 2.7 ENGINE SIZE

Thanks for your help. But I got the answer that I need.

SOURCE: car engine will not crank

on the starter there is a big battery cable and a small signal. wire connect a test light to the signal wire and try to crank the engine. if the light comes on then you will need a starter. be sure you have good connections first good luck.bye the way the light should only be on when you hold the key in crank pos.if the light is on all the time you are on the wrong wire.

SOURCE: find location for oil filter for oil filter for dodge intrepid

What engine? 2.7 passenger side on the bottom next to oil pan. 3.2 and 3.5 Drivers side coming off the side of block, near the front under the exhaust manifold.

SOURCE: chyrsler grand voyager wont start just clicks HELP!!!!!!!!!!!!!!!

What do you mean by bump started? The lights and radio can work, but the battery may be too weak to crank the engine over. The best thing to do would be to drive it to a parts store, where most offer free check of battery and charging system (if you can drive it. If not, 1st remove battery and bring in for testing). The click you hear is classic low battery symptom, although it can be other things. So, 1st get the free test, and post results back here. How old is the battery? (and answer 2 questions!) Thanks

SOURCE: My 1999 dodge intrepid is trying to start but wont fire up

try the crankshaft sensor. it is on the transmission bell housing on the passenger side. You could also check for codes by turning the key to the on then off 3 times (DO NOT START THE ENGINE) and it will give you any stored codes in the mileage display