Torque sequence -----------
' 9 7 3 1 5 '
' 8 4 2 6 ' ----------- Step
1: torque in sequence to 45 Ft/Lbs Step 2: torque in sequence to 65
Ft/Lbs Step 3: torque in sequence to 65 Ft/Lbs again plus 1/4
turn Step 4: Torque small bolt in rear of head to 25 Ft/Lb Recheck
final torque in sequence *** CAUTION ***engine uses
Torque To Yield head bolts (TTY) thatpermanently stretch during the
initial installation.New head bolts must be used when cylinder head
isreplaced or re-installed to obtain proper torque.
3.3L
80 Foot pounds (Final torque)
Application:
Cylinder head bolt torque sequence
Note :
Torque sequence -------------
timing ' 6 2 3 7 '
' 5 1 4 8 '
belt -------------
-------------
end ' 8 4 1 5 '
' 7 3 2 6 '
-------------
using torque sequence, final torque must
be reached in 3 equal steps
3.0L engine
×
SOURCE: How to adjust Ford 460 heads?
9 5 1 3 7
10 6 2 4 8
This is the head bolt sequence which should be torqued to 130-140 ft-lbs
Note: the numbers are represenative of the bolt location.
Mike...
SOURCE: NEED TORQUE SPECS AND SEQUENCE FOR 02 DODGE 2.4 V6 STRATUS
SOURCE: I need the torque specs and sequence on a 1998 chevy 350 vortec
Vortecs are a little different that old school small blocks, grab a Haynes or Chiltons, the cross patterns and specs are simply diagramed. Vortec, as any really, start with 25# then 45# and then final torque which I believe is around 70-75# but to be sure verify with the manual. AutoZones, Murry's, Adavance auto all carry the books, Cheap insurance.
Dan
SOURCE: i need torque specs on 93 dodge 360 ..heads,
Cylinder Head Bolt 5.9L
Step 1 - 50 ftlb
Step 2 - 105 ftlb
Step 3 - Recheck At 105 ftlb
Tightening sequence
Rocker Arm Bolt
5.9L - 17 ftlb
SOURCE: i need torque specs for a 2004 dodge cummins 24
http://www.dieseltruckresource.com/dev/index.php
I suggest this website for your dodge truck needs.
Foot pounds (Final torque)
Note:
Torque sequence --------- | 6 2 3 7 | | 5 1 4 8 | --------- Step 1: torque in sequence to 33 Ft/Lbs Step 2: turn an additional 90 degrees Recheck final torque in sequence *** CAUTION ***engine uses Torque To Yield head bolts (TTY) thatpermanently stretch during the initial installation.New head bolts must be used when cylinder head isreplaced or re-installed to obtain proper torque.
Foot pounds (Final torque)
Note:
Torque sequence --------- | 8 4 1 5 | | 7 3 2 6 | front --------- of engine | 6 2 3 7 | | 5 1 4 8 | Step 1: torque to 40 Ft/Lbs --------- Step 2: turn an additional 90 degrees Recheck final torque in sequence *** CAUTION ***engine uses Torque To Yield head bolts (TTY) thatpermanently stretch during the initial installation.New head bolts must be used when cylinder head isreplaced or re-installed to obtain proper torque.
1,321 views
Usually answered in minutes!
×