How can I change a power window motor on a 2003 Crown Victoria?
Remove the door panel. be very careful and make sure you get all the screws out. Should be maybe 2 on the bottom half of the door, and 2 on the top half. one is right by the handle, which is the one i forgot the first time i took my door pannel off. carefully pull the panel upward, and outward at the same time. Once the panel is off, disconnect the controls, and remove the light from the panel. Remove the plastic cover very carefully, it will tear, just keeps noise, and air, and the elements out.
There will be 3 screws, they are torx bolts, once you pull those 3 out. They are located middle of the door towards the right side. The motor will drop down a little bit. disconnect the wires for the motor, and wiggle the motor off of the regulator. the crown vics have a decent size hole to get into the door panel, you can also remove the speaker if that would help you do it. other than that, it just lining up the new motor into the car, pushing it into the regulator, and putting the 3 bolts in, make sure they are snug, and not cross threaded. put everything back together, and your set.
Pull the door panel then thers gona be a motor mounted there its gona be a tight squeze in the door there aint much room. hope that helps... JON
3,692 views
Usually answered in minutes!
blower motor defaulting to defrost
no dc power to anything
Where is the ecu crown victoria 2006
new blend door motor is there a reset for it
tem wot change after replacing blend door motor
×