Need to fix the cabel in the passenger side front window. it poped loose and window won't go up, but the cable itself is not broken and the motor is working.

Electrical Switch or bad motor. Usually corrosion is problem.

Each system is bad. The windows need regulators(they come with motors) the radio probably died(check fuse). And the mirror switch is bad(Since you still have power to the drivers window).

it has some dust in it

Greetings,
More likely than not, the issue has to do with your window motor. The safest and simplest thing to do is to replace the entire motor.

You can purchase a new window motor: HERE

Here is a guide for replacing it on your own: GUIDE

Likewise, you could also take the car to a shop, get a quote, and have them fix it (although this usually ends up costing more than it should).

Thank you for using FixYa.

The cable is broken. And unfortunately the motor track and cable is probably one whole assembly. So you need to replace it all as it is one unit.

This tells me the regulator is broken,the cable may have poped or a plastic wheel guide broke, you will need to replace the regulator, heres a picture to help explain what i'm talking about,

You will need to remove your interior trim panel and check your window regulator for damage and for power going to your window motor. If your regulator is ok and you have power going to the motor then you have a bad window motor. If there is no power at the motor then you will need to check the circuit for the problem ie. blown fuses, broken wiring, bad switch. It is very commen for the motors to go bad. Good luck.

if the fuse was an issue then all the windows would be inop, not just one, the most common fault is the electric motor that runs the window up and down.

replace the window regulator

Had to replace the switch cluster on ours. Same problem.

Also had problems with passenger side. Motor worked, but the window didn't move. Turned out to be a broken (rusty) cable in the window regulator.