I need to replace the ignition cinender - 1994 Oldsmobile Cutlass Ciera

Disconnect the battery: Before beginning any work on the electrical system of your vehicle, disconnect the battery to prevent accidental shocks or short circuits.
Remove the steering column cover: The ignition switch is located on the steering column, so you'll need to remove the cover to access it. Depending on the exact model and trim level of your Montero Sport, the cover may be held in place with screws or clips.
Remove the ignition switch: Once you have access to the ignition switch, you'll need to remove it from the steering column. This may involve removing any retaining screws or clips that are holding it in place, as well as disconnecting any electrical connectors.
Install the new ignition switch: Install the new ignition switch in the reverse order of the previous steps, making sure that it is securely fastened to the steering column and that all electrical connections are properly connected.
Test the new ignition switch: Once the new ignition switch is installed, reconnect the battery and test the switch to make sure that it is working properly. Insert the new key and try to start the engine. If the engine starts and the key can be turned smoothly, you've successfully replaced the ignition switch.
It's worth noting that depending on the specific make and model of your Montero Sport, the exact steps for replacing the ignition switch may vary slightly

no info generic answer unknown how much or type of damage --some vehicles can replace collar or need a full replacement column to rebuild /scavenge parts or replace whole

How to Reprogram the Ignition Key for an Oldsmobile Aurora

www.ehow.com > Cars

How to Reprogram the Ignition Key for an Oldsmobile Aurora. The Aurora is ...Replace the ignition switch in a 2002 Oldsmobile Alero after a thorough trouble-shooting session to eliminate issues with voltage, shorts, faulty grounds... How to ...

How to replace an ignition switch in a Oldsmobile Alero ...

? 14:05
https://www.youtube.com/watch?v=5FKwU467PKU
Mar 10, 2012 - Uploaded by BuckeyeBryan
How to replace an ignition switch in a Oldsmobile Alero. ... Showmore ... How to diagnose a bad starter, ignition, neutral safety switch!

GM How to Replace Ignition Lock Cylinder - YouTube

take center of steering wheel off,access the star screw through a hole in the wheel to remove mechanism

the ignition switch needs to be replaced

At you year make and model the factory alarm was just the pellet that disabled starter,the alarm was part of the ignition switch if anything you will need to replace the aftermarket alarm. A repair will cost you more than to replace the unit,You will have to cancel the aftermarket alarm under the dash and restore the ignition wire that is spliced for the alarm relay.

you need haynes repair manual for 1993 suburban it has photos and information you need to help you replace ignition switch.i am mechanic i use haynes,chiltons and gm manuals.if you are a home mechanic do it your self you need haynes repair manual it has step by step instructions to remove the steering wheel and remove lower steering column reason i say need haynes repair because your steering wheel has a air bag in it you need to see how to remove air bag in steering wheel you need to read through the entire ignition switch removal procedure if you are going to replace ignition switch with keylock cylinder you will also need steering wheel puller. you need a tool compress lock plate to remove lock plate retaining ring from steering shaft in order to get to the ignition switch in the steering column below turn signal switch.

YOU WILL NEED TO REPLACE THE IGNITION SWITCH. CAN USE GRAPHIET IN KEY THEN PUT INTO IGNITION THS WILL BUY YOU SOME TIME BUT ULTIMETLY YOU WILL NEED TO REPLACE IT

You only need to replace ignition switch.

two things for this one the ignition cylinder is bad need to replace second the ignition cable is bad and need to replace or adjust right