At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Re: Is they a relay for the air suspension on a 97 buick...
On the right rear lower control arm is a leveler switch, I would check it first, check for power, I know that when checking for power you can activate the air pump with a test light, and yes there is a relay
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
There's nothing to reset. Check the fuse for the compressor. The level sensor electronics attached to the suspension parts on the rear wheels may be defective which won't allow the compressor to operate if the fuse is not blown.
repairpal.com > Problems > Buick > Park Avenue Buick Park Avenue Engine Stalling Due to Mass Air Flow/Crankshift Position Sensor Failure. This is a verified ... 1997 Buick Park Avenue- 3.8L V6160,000Visitor. Engine stalls ... car runs then stalls and won't start for thirty minutes. Upvote (36).
Buick stuttering Questions & Answers - Fixya
www.fixya.com > Forum > Tags > stuttering 94 Buick Park Avenue that stutters under a light load I have a 94 Buick Park Avenuethat ... Buick Century 97 runs rough and stutters when cold and gas applie Engine runs rough ... I have a 1994 buick lesabre it starts ok but stutters and stalls.
the simplest way to check a relay is to swap it with a relay from somthing that you know works (eg. starter, or horn) if that item still works after the swap then the relay is good.
Well, that can be a ton of things. Usually it means: A. its not getting enough air, or any air. B. Its not getting enough gas. It could be a problem with the Mass flow Sensor- which can be cleaned or replaced-, or maybe a bad fuel pump or bad fuel lines or something. Either way the problem sounds like it just can't run because it can't get enough gas.
×