How do u put oil catch can on 04 rsx - 2004 Acura RSX

ensure you have enough transmission fluid, let vehicle run to warm up oil, block wheel and put transmission in neutral and verify oil while engine running, adjust as needed, if that doesnt work, possible torque converter mal function or shift solenoid, also check engine goes with a scan to verify possible transmission codes

Add oil.

all engines, its in one of 3 places. so........ easter egg time.....again,.
why>? the ECU reports it bad, why wonder??????
the engine parts are all displayed at honda.
why not look there.
here. 9 sub models of civic, more actualy, sedan, coupe etc..
and ex, to gx. bla bal

i pick sedan LX (wild guess)
wonderment. 101
case in point ID #14

http://www.hondapartsunlimited.com/honda/civic-sedan/37500plc015/?year=2002&trim=lx&engine=4-speed-automatic&group=engine&subgroup=oil-pump-oil-strainer&part_name=sensor-assy-crank


so , you answer all those questions there.
and get sensor
Crank sensor search there works
and can be different spot with different engine.

gen 7 car
K series engines began that year.

• (03+) 01+ K20A Integra TYPE-R; Civic TYPE-R; Accord Euro R (Japan)
• 02-04 K20A2 RSX Type S (America)
• 01+ K20A3 Integra IS (Japan)
• 01+ K20A3 RSX Base, Civic Si (America)
• 03+ K20B 2.0l VTEC-i, Stream 4WD (Japan)
• 03+ K24A Accord; Accord Wagon (Japan)
• 03+ K24A2 TSX 200 (America)
• (03+) 02+ K24A3 CRV; Element; Accord
• (03-05) K24A4 2.4L VTEC-i Honda Accord

as you can see we;'d NEVER guess the engine. ever.
open hood (USA) look up see EPA sticker it TELLS which of above you have.
bingo?

why not post symptoms so we cans stop the guessing game.
why>?

Get a long shank screw driver and place it on the starter. While a friend attempts to start the car, tap the handle of the screw driver with a ball pin hammer. Sounds like the pin is catching upon deployment. Eventually your going to need to replace the solenoid and the starter.

I HAVE AN 04 ACURA RSX 2.0LV-TECH, AND IVE REPLACED THE BATTERY BUT ITS STILL ACTING LIKE THE BATTERY IS DEAD AND ITS SLUGGISH TO TURN OVER. IM LEANING TOWARDS THE STARTER BUT WOULD LIKE A SECOND OPINION.

The tentioner should keep the belt at the right tention. Are you sure its the belt? I had some squeaking in my 05' RSX and replaced the Tentioner Pulley and the squeaking went away. Maybe this could be the same case. Hope this helps.

take it back to acura cuz you just paid $100 an hour and complain about the problem it should be warranty cuz it sounds like they may left something unplugged for what reason not sure

I can tell you that on a 2003 you put the key in the ignition and press and hold the odometer reset. While holding the odometer reset turn the key to accessory. After a second or 2 the light should go off and then release the reset button.

no...the car will be fine. 

you might have water or condensation on your gas lines. put an additive that removes condensation from the gas lines and see how that works for you.