Does 2006 Chevy Colorado 5 cylinder engine have timing belt

Question edited for clarity.
Question moved to category.

5. One for each spark plug.

https://www.google.com/search?q=05+chevy+colorado+3.5+coil+packs

..

Question edited for clarity.
Question moved the Colorado sub-category.

I wonder is you picked something up and the serpentine belt whipped the stick or whatever and disconnected the crankshaft position sensor. Can you reconnect it and start the vehicle?

Try putting your seat belt on before even putting the key in switch and starting the vehicle. It may only be your seat belt alarm dinging. Mine does that very same thing, so I belt up first every time. Then it doesn't do the dinging.

at bottom of timing cover behind crank pulley

Replace the sparkplug

autozone rents the tensioner tool

must be talking about chevy canyon and colorado.your truck has timing chain,timing chain is reliable for 100000 miles or more,depends on how engine treated.

This is for the 5 cylinder 3.5 liter engine in the Colorado

1. The drain plug is in the middle of the oil pan on the drivers side.
Use a 15 mm socket or box end wrench to remove the plug. Drain
oil.
2. The oil filter is at the bottom front corner of the engine on the passenger side. Remove the filter. Try not to tip the filter when you
remove it so you don't get oil on other parts of the truck.
3. Rub a small of oil on the gasket of the new filter. Spin on the new filter, 3/4 to 1 turn past when the gasket starts to seat. Hand tighten
only.
4. Reinstall the drain plug. DO NOT OVER TIGHTEN OR YOU COULD
STRIP THE THREADS.
5. Add 6 quarts of oil to the oil filler tube located on top of the engine
in the front and middle of the engine compartment. It shows the location
in the owners manual. Install the filler cap.
6. Start the engine and let it run a few minutes to fill the filter with oil.
Turn off the engine and wait a few minutes for the oil to drain down to
the bottom of the engine. Remove the dip stick and check oil level.
Checking oil level is in the owners manual.

change the ignition switch!!!!!! went to the shop six times until they changed the damb switch!!!!