How to reset "maintenance required" warning light

This light is warning you of maintenance required... presuming you did maintenance required.. you can reset light by following the steps in video below. If there is a problem that is still needing service... this light will come back on.
Hope this helps you.
https://www.youtube.com/watch?v=sBaMNHsEobs

Maintenance required light could mean its time for an oil change. Do you have a check engine light too ?
The battery/brake light can mean the brake fluid is low or the battery is not being charged by the alternator.

Hi.

The light means that the maintenance interval is over and that service is required. The procedure to turns off the light is reported on the owners manual but you are strongly advised to do service at intervals prescribed by manufacturer. Service will consist in oil change, fluids change, filters and general inspection.

Here the general procedure to reset service light.

1. Turn the ignition key to the 'OFF' position with the trip meter A reading shown.

2. Turn the ignition key to the 'ON' position while holding down the trip meter 'RESET' button.

Hold down the knob for at least 5 seconds. The odometer indicates '000000' and the light goes off.

Perform service as soon as possible.

Regards.

Ginko

It's just a mileage-triggered light that reminds you to perform routine maintenance on your vehicle. It can be reset. Instructions to reset should be found in your owners manual or on Youtube.

normally disconnecting the battery for about ten minutes then reconnecting is enough to reset the computer and get the light to go out. although is there is a existing problem i will come back on after about 10 minutes of driving.

Welcome to FIxYa.com

Oil Change light:

To reset the "CHANGE OIL" light, turn the ignition switch to the run position with the engine off. Fully depress and release the accelerator pedal three times within 5 seconds. The light will flash twice and go out.

Maintenance warning light? MIL? Check engine? Maintenance Required?

You will have to go to Auto Zone to have the code read and then fix the code problem and then clear code with code reader

Regards, Lee Davidian

Thank you for using FixYa.com

maintenance may have been done, but your indicator needs to be reset.
How this is done, I don't know. But, you might ask the dealership.

put the odometer on trip a turn the ignition off then hold in the trip button while turning the ignition to the on position then you will see 5 ----- count to zero thats all there is to it if this doesnt work read the owners manual

hold the trip button in, now turn the key on, keep holding until light goes out.

1. Push the “ODO/TRIP” button to change the display to
blank.
2. Turn the ignition off.
3. Turn the ignition switch to “ON” with the trip meter
“RESET” button held down.
4. Keep pushing the “RESET” button for longer than 5
seconds after the ignition is turned on.
After the above operation, the master warning light comes
on, a warning tone sounds and the message
appears to inform you that the engine oil maintenance data has been reset.