1995 honda accord abs light stays on - Accord Honda Cars & Trucks

get the ABS scanned.

read the FSM?
read the TSBs?
car off then on, you mean starting,
and the only difference is the time off, ?
the abs glow, key on?, is self test passing, if you flip key fast and drive it crazy , you are the problem. let the poor thing finish its tests, key on, then start car.


the tests are in the FSM read it, ABS is complex.
ill try to look up 95, on line.

the 95 ABS has its own diagnostic jumper plug
did you jumper it and see if there are any DTC error codes, flashing out.?

the FSM page 19-68-70

see those flow charts, did you follow it?
did you see the list of 10 causes, for lamp stuck on? (not DTC)
one is alternator stuck on. charge lamp on, running.

here you can look for free. RTM,
http://hondatech.info/downloads/Auto/Manuals/Accord/

There must be an intermittent problem with your abs system, which causes the abs light to come on and then go off, as you say. It won't affect your brakes, just your anti-lock braking function. if that light is on. If it remains on, have it checked.

If it doesn't turn off by its self after a few cyacles of operation, unhook the battery for about half an hour, then reconnect

ABS failures are common in the Honda Accord and the Honda Odyssey, especially during the 1995-1997 years. You will find that your ABS light will come on intermittently and then go out. Finally, the light will come on and stay on until the system is replaced. Honda has been charging owners about $1500 to replace the modulator and accumulator. Honda maintains that this is not a problem that is widespread. The Honda owners' notes show that the problem usually happens betwee n 50,000 miles and 100,000 miles. There is a buzzing associated with the system failing, too.--------------
try bleeding the ABS brake pump and check. You must bleed the abs pump, then reset the abs computer by removing the ABSB2 fuse.--------------

Thanks. Keep updated for any more query. You can rate this solution and show your appreciation

try cleaning sensors behind rotor with brakekleen or something similar had similar problem on my truck & that fixed it road salt & dirt got on sensor

if the abs light is already on the abs system is already bypassed, and your base brake system should operate without the abs working properly as long as the red brake warning light is not on

broken wire in the wheel hub

no mate the computor should ,if all is ok reset it self if it not doinng so then the prob is still there. didi you use the exact same relay and i have just replaced thr comletye modulator on one (where abs pump is ) becauase the motor was faulty , try takin a peise of wire and bridging th two big terms of the relay plugs out and you should here a audiable little motor run if not replace unit