- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
700 is generic code meaning a transmission malfunction. It could electrical or mechanical. You'll have to retrieve the other codes. The solenoid packs are the most common parts replaced on these.
It means there is at least one transmission code set in the TCM's memory. P0700 is an informational code only. More diagnosis is necessary to identify what the transmission fault is. This requires a scan tool that will communicate with the transmission module http://www.obd-codes.com/p0700
Type in odb2 po700 in google and it will pull up your answer. The other 2 codes im unformiliar with. May mean you need to update your obd2 code reader software or those are transmission codes. Go to auto zone or orielies
code p0700 is the transmission control module (TCM) fault.. Check that there is power from the ignition switch in the start position either to the starter solenoid or to the starter relay.. If there is power tom the solenoid then the fault may be in the solenoid. IF there is power to the relay and it clicks then the fault may be in the relay (check voltage on the starter wire out ) or the starter solenoid.
The code 700 is a notice that there is a problem with the trans control module, and code 1776 could be a problem with the low-reverse solenoid inside the trans. Code 1776 can trigger the code 700. The solenoid would need to be tested.
the po700 code will be found in the engine controller all it means is there is a code preasent in the trans controller a good scan tool is needed to communicate with trans controller to retrieve the stored codes that specify problem
This code is simply telling you to checkfor transaxle codes. if they tell you that the TCM is bad . They are wrong. you need to get a special code for the transaxle. Sorry, but thats all the P0700 code means.
×