SOURCE: tailgate will not latch
you need to replace handle, or either look to make sure linkages are still hooked up. if they are hooked 2 of them and it doesnt work definately handle.
SOURCE: chevy blazer 95 with stuck trunk
I was able to get two wedges between the glass and the plastic trim. From that I used a scope to see inside and find the mechanism to release the window. Once I got the glass open, I removed the handle, and two screws from each side of the trim and removed the trim.
Once the trim was removed I had a small opening and could see the problem. The end of the latch has a small blue plastic (why plastic??) catch that broke.
Rather than taking the door apart and finding a replacement, I heated a screw driver and made a slot in the plastic. Next I used a heavy duty zip tie and connected the two pieces (plastic catch and metal part that opens the latch). I left some slack in the connection and all works great.
Not sure how long this will last, but for now I have the back opening. I will look at replacing the plastic piece, but not sure if a total new mechanism is needed.
Thanks
Stan
SOURCE: 1998 Chevy Cavalier trunk release issue PLEASE HELP
Well I had the same problem after I ran into a tree from the back. I hadnt opened my trunk since the incident and when I finally opened it it wouldnt close.
If it will hold the ball point pen, then its not the lock mechanism. But If you look at the bar that it connects to, it might be obstructed. I had to hammer the hell out of the metal parts surrounding the bar to knock the metal parts down. And it closed. So the problem was that the connecting bar was too short. So try to knock all the metal around it to free it and make it a longer bar.
SOURCE: trunk latch wont hold shut on my 02 cavalier
Make sure it is not binding/sticking where you pull the release cable.
Drench the entire works in WD-40. Push it back and forth until it moves with no resistance.
Make sure the part that hooks onto the latch hasn't come loose enough to not slide over when it makes contact.
If that doesn't work, take the whole thing off. You'll have to anyway to replace it. Chances are with it disassembled you'll see what's wrong.
SOURCE: my key wont unlock the trunk anymore but the remote opener does.
There is a cable that runs from the key cylinder to the latch mechanism. There are clips that hold the cable housing in place, and if one of those comes loose then turning the key just moves the housing without releasing the latch. Check the clip closest to the latch. To get the trunk open drop the back seat, crawl in, and pull on the cable.
It is also possible that the cable is broken or damaged and needs to be replaced -- I assume you will then need to replace the enrite assembly.
61 views
Usually answered in minutes!
×