Raise trunk lid look on the inside behind your license plate light there should be access to the bulb there. You will see the wires going in to the bulb there will either be a flt plate that can be removed to access bulb or where the wires enter there will be a round socket that you can twist counter clockwise and remove the bulb socket for bulb replacement. hope this helps.
Follow
the Steps on how to replace license plate light on your car.
1.
Open the trunk and locate the trunk liner retainer clips.Use the
Phillips head screwdriver to loosen the center plastic screw of the
retainer clip about 1/4 turn, just enough to raise the head of the
screw from the base of the clip. Pull the screw up, and lift the
clip out of the liner. Use a flathead screwdriver to help pry it
out. Remove enough of the clips to allow access to the license plate
light sockets. Pull the liner back.
2.
Remove the emergency trunk release handle by popping off the top
cover of the handle. Use the needle nose pliers to gently squeeze
the prongs on the shaft, while removing the handle.
3.
Unplug the wire harness from the license plate light bulb socket the
release clip on the side of the outlet.Twist the license plate light
bulb socket 1/4 turn counterclockwise, using the needle nose pliers
again. Do not apply too much pressure to the pliers; you may damage
the socket.
4.
Remove the bulb from the socket, and replace it with a new one.
5.
Replace the socket into the socket assembly, and plug the wire
harness back in. Test the bulb by turning on the lights of the
Corolla, then turn them off again.
6.
Replace the trunk emergency release handle, and replace the hood
liner and the retainer clips. Remove the old bulb and tools, and
close the trunk.
1,269 views
Usually answered in minutes!
×