-
Chrysler Master
5,370 Answers
- Posted on Jan 12, 2011
Re: I need the exact location of the break light switch...
The brake light switch is mounted to the brake pedal bracket assembly, under the instrument panel. The stop lamp switch attached to the mounting bracket.
- Disconnect the negative battery cable.
- Unplug the two brake switch wiring harness connectors.
- Remove the wiring harness for the switch from the clip on the brake pedal bracket assembly. Remove the nut and washer from the switch and bracket assembly stud and remove the switch and bracket assembly. To install:
- Position the switch and bracket assembly to the brake pedal bracket assembly, then install the nut and lockwasher. Tighten the retaining nut for the bracket until finger-tight (loose enough to allow movement of the bracket).
- Attach the electrical wiring harness connectors and route the wire through the retainer clip.
- Push the switch forward (toward the front of the vehicle) as far as it will go (this will cause the brake pedal to move forward slightly).
- Gently pull backward (toward the rear of the vehicle) on the brake pedal until the pedal lever rests against the its stop. This will ratchet the switch back to its properly adjusted position.
- Tighten the switch and bracket assembly mounting bracket nut securely.
See fig for more detail:--
--------------
This should help.Thanks.Helpmech.
×