Need to replace both brake lights - 2007 Hyundai Accent GS Hatchback

Did you bleed the brakes after you replaced the 2 brake lines. Did you breed the brakes with or with out the power on.The right way to bleed brakes with abs is with thew power off. you will need a abs scan tool and re bleed the brakes

P0703 Suzuki - Brake Switch Circuit Malfunction
Possible causes
- Faulty Brake Switch
- Misadjusted Brake Switch
- Brake Switch harness is open or shorted
- Brake Switch circuit poor electrical connection
Check if the stop light works with the brake pedal, if the brake lights are inoperative, replaced or adjust the brake switch.
Symptoms:
- Engine Light ON (or Service Engine Soon Warning Light)
- Brake lights inoperative

maybe the bad connection.
____________
airbag reset tool

Light gets power from brake light switch/.May be switch got shorted an brake light getting non-stop power causing it not to turn OFF brake light.

Get the brake light switch checked. Check volt at brake light switch.

It can be faulty brake light switch causing the problem or its wiring short for switch.

==========

To trouble shoot brake related problem, check the help links mentioned below:-----

Click the link:----

1996 Buick Regal Grand Sport Brake light Switch Location?

http://schematicsdiagram.blogspot.in/2012/04/1996-buick-regal-gran-sport-brake-light.html

-----------

No brake lights on Buick?

http://schematicsdiagram.blogspot.in/2012/04/no-brake-lights-on-buick.html

----------

Brake lights not working on 1989 BUICK REGAL?

http://schematicsdiagram.blogspot.in/2012/04/brake-lights-not-working-on-1989-buick.html

-------

How to replace Brake light switch on Chevrolet Tahoe?

http://technoanswers.blogspot.in/2012/02/how-to-replace-brake-light-switch-on.html

---------------

How to replace Parking, turn, and Brake Lights on car?

http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-parking-turn-and-brake.html

----------

Upper brake lights work, but low brake light not working?

http://schematicsdiagram.blogspot.com/2011/12/upper-brake-lights-workbut-low.html

------------

1997 Cadillac Catera: How to replace Brake Light Switch?

http://howtobyme.blogspot.in/2012/06/1997-cadillac-catera-how-to-replace.html

------------

1996 Chrysler LHS brake light circuit wiring diagram?

http://technoanswers.blogspot.in/2012/02/1996-chrysler-lhs-brake-light-circuit.html

----------

How to replace rear Brake lights on 2004 Toyota RAV4?

http://schematicsdiagram.blogspot.in/2012/02/how-to-replace-rear-brake-lights-on.html

------------

One brake light on driver side not working, but other lights work?

http://schematicsdiagram.blogspot.com/2011/12/one-brake-light-on-driver-side-not.html

----------

2002 Lincoln Town car Fuse Box

http://schematicsdiagram.blogspot.com/2012/11/2002-lincoln-town-car-fuse-box.html

2007 KIA Rio: Brake Light Fuse Box Diagram?

http://repairhelpcenter.blogspot.in/2012/06/2007-kia-rio-brake-light-fuse-box.html

-------------

Overhead Brake lights not working on 1999 GMC Sierra 4x4?

http://technoanswers.blogspot.in/2012/03/overhead-brake-lights-not-working-on.html

---------

Brake lights not working

http://schematicsdiagram.blogspot.com/2012/11/brake-lights-not-working.html

-------

2004 Ford Mustang: Brake light Fuse Location?

http://howtobyme.blogspot.in/2012/05/2004-ford-mustang-brake-light-fuse.html

---------

These will help.

Thanks.

CHECK BRAKE LIGHT SWITCH TO SEE IF ITS TOUCHING THE BRAKE PEDAL.IF BRAKE LIGHT SWITCH OR BRACKET LOOSE AND AWAY FROM BRAKE PEDAL BRAKE LIGHT WILL STAY ON.IF BRAKE LIGHT SWITCH INTACT BRAKE LIGHT SWITCH NEED REPLACING.WHEN REPLACING BRAKE LIGHT SWITCH OR IT NEEDS ADJUSTING MAKE SURE BRAKE LIGHT SWITCH PLUNGER TOUCHES BRAKE PEDAL ARM WHEN YOU RELEASE BRAKE PEDAL BRAKE LIGHTS SHOULD TURN OFF.

replace your stop light switch located up under the driver's side dash touching the brake pedal arm (lever)
it has a pin that comes out turning the brake lights on when you press on the brake.
the master brake cylinder returns the brake pedal when you release it; the stop light switch button is pushed in turning the brake lights off again. then: if there is another problem I will help you but, this is what you need to do first.

NO....two seperate problems...As far as the rotor, you may need to replace it, with some new pads...( If the rotor can not be resurfaced) ..Now you replaced the switch, and you checked your fuses...OK..Did you check the bulbs? And if all those things are good, then you have a open in your brake circuit.. Meaning you need to trace the wires back from the brake lights with a test light, and follow them all the way to the brake switch, or you can start from the brake switch go go back towards the lights..( It's up to you). Now If you go from back to forward, when the light comes on, thats where you will need to repair..from there back...Now if you go from forward to back, when the light goes off, thats where you will need to repair...Goodluck...

hi there,
this sounds like your brake pad wear sensor light, it lets you know when your pads need replaced, hence the difficulty in braking,.the front ones usually need replaced before the rear ones, as they wear out faster, due to the 70/30 front to rear braking ratio

Brake light switch located on the brake pedal bracket.

Brake light not turning off it is either a contact or the brake light switch that need replacement. In your case , if brake lights go off playing with the pedal , that means that the switch must be replaced. The brake light switch it is usually located behind the pedal and gets activated when you push the brake pedal.