1994 chevarlet camaro 3.4 v6

1994 Chevrolet Camaro 3.4L SFI 6cyl

The Control Module-Ignition is located: Under hood, center, front engine area, below valve cover, mounted in distributorless ignition assembly

1994 Chevrolet Camaro 5.7L SFI OHV 8cyl

The Control Module-Ignition is located: Under hood, center, rear engine area, mounted in distributor

Engine Coil Pack
5 6 / #4 / / #3 / / #5 /
3 4 / #1 / / #6 / / #2 /
1 2
Front Ignition Wires on Coils
#1 #4 #6 #3 #2 #5
' ' ' ' ' '
O O O O O O

Firing Order: 1-2-3-4-5-6

I have no idea what's going on here...lol

Are you check right "firing order" ? Some "check engine" light on dashborad turn on?

you might be able to take it from the hose that goes to your brake booster as it is vacuum operated ,or anywhere else on the inlet manifold even if you have to drill a hole & tap a thread so as you can screw a fitting into.....hope this helps.....cheers

REMOVE POWER BRAKE BOOSTER HOSE ON THE INTAKE.BUY A SMALL PIECE OF THE SAME HOSE TO POWER BRAKE BOOSTER.PUT IN ON POWER BRAKE BOOSTER VACUUM PORT AND BUY A REDUCER SO YOUR VACUUM GAUGE HOSE WILL FIT.THEN CRANK CAR UP CHECK ENGINE VACUUM.

You'll need to remove the heads. Take them to a machine shop. They will do a valve job, check the heads for cracks, check for bad valve guides and replace the valve stem seals.

located on the left cylinder head. at the front. it is right where the power stering is

1994 chevy truck heater contol will not go to def

generally if it is a sensor you should be able to retrieve a fault code. Other things to chek, timing, vacuum leaks, EGR. valve, fuel filter, plugged injectors, spark plug ( gap ), lead wires, distributor cap, rotor.Hope that this will help you. Good luck and remember to rate all replies you get. Thanx.