Question about 2006 BMW 750Li

1 Answer

Driver window will not operate - 2006 BMW 750Li

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 38 Answers

The window motor has probably worn out. They are cheap to replace and can be done in less than 10mins. Very simple to undertake yourself.

Posted on Jan 09, 2011

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Power windows wont roll up or down on 2006 Cadlliac cts


With the electronic's involved ,your best bet would be to take to a qualified repair shop . The door 's have electronic control module inside that control door lock's an window operation . Hooking up a professional or factory scan tool an viewing input data an checking DTC'S - diagnostic trouble code's would be the first step any professional technician would do . You probably have no idea what these are ? Messing with these systems can render your vehicle unuseable if you do not know what you are messing with .

Power Windows System Components
The following components are used to control the power windows:
• Driver door module (DDM)
• Passenger front door module (PDM)
• LH rear door module (LRDM)
• RH rear door module (RRDM)
• Driver door switch assembly (DDSA)
• RH front power window switch
• LH rear power window switch
• RH rear power window switch
• LH front power window motor
• RH front power window motor
• LH rear power window motor
• RH rear power window motor
• Class 2 serial data link
• DR MOD PWR C/B 30 Amp circuit breaker
• DRIVER DR MOD 10 Amp fuse -- DDSA and DDM logic, DDM internal driver operation.
• PSGR DR MOD 10 Amp fuse -- PDM logic and internal driver operation.
• REAR DR MOD 15 Amp fuse -- LRDM and RRDM logic and internal driver operation.
Power Windows Operation
The vehicle is equipped with power windows controlled by the door modules. Each passenger door window can be operated, either from a power window switch built into the driver door switch assembly (DDSA) , or, from a power window switch mounted locally on its associated door. The driver door window can be operated only from the driver door power window switch built into the DDSA.
When the driver door module (DDM) receives a driver door window switch request from the DDSA, the DDM examines the request and inspects to see if it has received any messages from any of the other vehicle modules prohibiting the movement. If no prohibitive messages have been received, the DDM then applies power and ground to the driver door window motor to move the window as requested.
When a passenger door module, passenger front door module (PDM), LH rear door module (LRDM), or RH rear door module (RRDM), receives a window switch request from, either the DDSA or the window switch mounted locally to its door, the passenger door module examines the request and inspects to see if it has received any messages from any of the other vehicle modules prohibiting the movement. If no prohibitive messages have been received, the passenger door module then applies power and ground to its associated window motor to move the window as requested.

So do yourself a favor an take it to a qualified repair shop.

Nov 22, 2017 | Cars & Trucks

1 Answer

How do you remove the right front door panel on a 2004 buick le saber


Did you test it or are you guessing just because it won't open or close ? How To Install Remove Front Door Panel Buick Lesabre 00 05 1AAuto com both right an left are the same .
Power Windows System Components
The following components are used to control the power windows:
?€¢
Driver Door Module (DDM)


?€¢
Passenger Front Door Module (PDM)


?€¢
LH Rear Door Module (LRDM)


?€¢
RH Rear Door Module (RRDM)


?€¢
Driver Door Switch Assembly (DDSA)


?€¢
RH Front Power Window Switch


?€¢
LH Rear Power Window Switch


?€¢
RH Rear Power Window Switch


?€¢
LH Front Power Window Motor


?€¢
RH Front Power Window Motor


?€¢
LH Rear Power Window Motor


?€¢
RH Rear Power Window Motor


?€¢
Class 2 serial data circuit


?€¢
Power door serial data circuit


?€¢
PWR WDO 30 Amp Circuit Breaker


?€¢
DRVMDL Fuse (10 amp)


Driver Door Switch Assembly and Driver Door Module logic, Driver Door Module internal driver operation


?€¢
PASS MDL Fuse (10 amp)


Front Passenger Door Module logic and internal driver operation


?€¢
RRDR MDL Fuse (10 amp)


Left Rear Door Module and Right Rear Door Module logic and internal driver operation


Do you know about computer controlled power windows ?
Power Windows Operation
The vehicle is equipped with power windows controlled by the door modules. Each passenger door window can be operated, either from a switch built into the driver door switch assembly (DDSA), or from a switch mounted locally to its associated door. The driver door window can be operated only from the driver door window switch built into the DDSA.
When a window is operated from the DDSA, the DDSA interprets the window switch signal as a specific window switch request and sends the information to the driver door module (DDM) via the power door serial data circuit. The DDM examines the request and checks to see if it has received any class 2 serial data messages from any of the other vehicle modules (i.e. ignition switch position) prohibiting the movement of the window. If the window being operated is the driver door window, and if no prohibitive class 2 messages have been received, the DDM then applies voltage and ground to the driver door window motor to move the window glass as requested. If the window being operated is a passenger door window, and no prohibitive class 2 messages have been received, the DDM sends the request, via the power door serial data circuit, to the appropriate passenger door module. The passenger door module then applies voltage and ground to the passenger door window motor to move the window glass as requested.
When a passenger door window is operated from the power window switch mounted locally to its associated door, the passenger door module first checks to see if the DDM has received any prohibitive class 2 serial data messages. If there are no prohibitive messages, the passenger door module powers the associated passenger door window motor.
Both front door windows have the express down feature. This allows the front door windows to be fully opened by momentarily pulling the appropriate window switch lever to the second detente and then releasing.

Oct 30, 2016 | Buick Cars & Trucks

1 Answer

The battery got disconected now windows dont work tried re program checked fuses nothing now what


You need to do a window reset. Its in your owners manual

This is a quote from the workshop manual

Note
? A driver side window will not fully close automatically under following the conditions:
? The battery has been disconnected during vehicle maintenance or for other reasons.
? The power window main switch connector, or driver-side power window motor connector has been
disconnected.
? Carry out the following procedure to resume operation:
1. Turn the ignition switch to the ON position.
2. Press the driver side power window main switch and fully open the driver side window.
3. Pull up the driver side power window main switch to manual-up position to fully close the driver side window,
and keep holding the switch up at the position for about 2 seconds to complete initial setting.

TWO-STEP DOWN FUNCTION OPERATIVE/NON-OPERATIVE SWITCHING PROCEDURE

Note
? By following the procedure below, the two-step down function is switched to non-operative when it is
operative, and to operative when it is non-operative.

Turn the Ignition on
Within 5 sec
perform the auto open two times
perform the auto close two times

turn the ignition off and within 40 seconds and repeat the above sequence.

Repeat for all the windows.

Aug 14, 2016 | 2007 Mazda 6 2.3

1 Answer

Where is the power window relay located in 2004 bonneville pontiac? thanks


Are all the windows inoperative ? The power window system on this vehicle is very complex in nature . Door modules , serial data communication networks ,messaging commands between modules etc... Factory description
Power Windows Operation
The vehicle is equipped with power windows controlled by the door modules. Each passenger door window can be operated, either from a switch built into the driver door switch assembly (DDSA), or from a switch mounted locally to its associated door. The driver door window can be operated only from the driver door window switch built into the DDSA.
When a window is operated from the DDSA, the DDSA interprets the window switch signal as a specific window switch request and sends the information to the driver door module (DDM) via the power door serial data circuit. The DDM examines the request and checks to see if it has received any class 2 serial data messages from any of the other vehicle modules (i.e. ignition switch position) prohibiting the movement of the window. If the window being operated is the driver door window, and if no prohibitive class 2 messages have been received, the DDM then applies voltage and ground to the driver door window motor to move the window glass as requested. If the window being operated is a passenger door window, and no prohibitive class 2 messages have been received, the DDM sends the request, via the power door serial data circuit, to the appropriate passenger door module. The passenger door module then applies voltage and ground to the passenger door window motor to move the window glass as requested.
When a passenger door window is operated from the power window switch mounted locally to its associated door, the passenger door module first checks to see if the DDM has received any prohibitive class 2 serial data messages. If there are no prohibitive messages, the passenger door module powers the associated passenger door window motor.
Both front door windows have the express down feature. This allows the front door windows to be fully opened by momentarily pulling the appropriate window switch lever to the second detente and then releasing.
I have heard of water on rear floor shorting the data bus bring down the system . no power window operation . There are bus wires under the carpet an a scotch lock connector that corrodes causing this problem . This may or may not be your problem but you can stop looking for relays because their are none involved in the control of the power windows on your vehicle .
I

Jun 23, 2016 | Cars & Trucks

1 Answer

Child safety lock


This is in the design of the window lock. In order for the driver to operate the other windows this switch must be turned off. Windows locked are windows locked. You cannot over ride this function without damaging the system.

Apr 05, 2014 | Honda Odyssey Cars & Trucks

1 Answer

2004 Toyota tundra passenger power window switch not operational


Try a passenger side door switch or a new complete master switch on drivers door. Alaways check fuses also.

Jun 16, 2012 | 2004 Toyota Tundra Cab

1 Answer

2001 aurora power window/lock failure.


Power Windows Operation
The vehicle is equipped with power windows controlled by the door modules. Each passenger door power window can be operated, either from a switch built into the driver door switch assembly (DDSA), or from a switch mounted locally on its associated door. The driver door power window can only be operated from the switch built into the DDSA.
If the driver door module (DDM) receives a window switch request from any of the window switches built into the DDSA, the DDM checks the Class 2 serial data to see if conditions are correct (i.e. ignition switch position) to permit window operation to occur. If conditions are correct, the DDM, either supplies power and ground to its associated window motor, or sends a command via the power door serial data line to the passenger door module controlling the window. The passenger door module controlling the window then supplies power and ground to its associated window motor to move the window as requested.
When one of the local window switches mounted on one of the passenger doors is operated, the associated passenger door module examines the request and checks to see if there are any messages from the DDM prohibiting the window operation. If conditions are correct, and no prohibitive messages have been received from the DDM, the associated passenger door module then supplies power and ground to its associated window motor to move the window as requested.


Class 2 data network wires under the carpet behind driver seat. Water shorts out the network an and it won't work .
your looking for tan/white wire's and a connector . This is where the problem is .

Aug 13, 2017 | 2001 Oldsmobile Aurora

1 Answer

Both rear windows will not operate from the rear controls, but drivers control will operate them.


Either the window lockout switch is engaged on your driver's side window switch (I believe the switch has a graphic of a window with an X on it) or your master switch (driver's switch panel) is defective.

Oct 21, 2009 | 1999 Ford Explorer

1 Answer

2003 Forester, only driver's side window works


the first thing i would check is the master window switch, on the drivers door, the window lock circuit locks out the operation of the other three windows. the intermittent operation of the windows suggests a possible loose connection or contact.

Dec 14, 2008 | 2001 Subaru Forester

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Doberman

Level 2 Expert

261 Answers

auntyjack

Level 2 Expert

104 Answers

Roy Cunningham

Level 1 Expert

35 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...