I have to replace rear wiper motor of my pontiac montana SV6 3.5L 2006. Pls explain step by step. How do I take out the outside wiper arm/assembly? Appreciate if you pls explain this starting point in detail. Also the proper steps to take out the inside trim (w/o damaging the trim), to access the wiper motor.

SOURCE: real right turn signal light - Pontiac Montana SV6 2005

If the 2005 Montana is similar to the 2001 Montana, I have a solution. First you'll need a hexagonal wrench (the 6-sided L-shaped wrench). The tail light assembly is held on by two screws. You'll need the hexagonal wrench to remove them, because a normal screwdriver won't do it. I also had to use a conventional adjustable wrench to get the leverage to turn the hexagonal wrench, because the screws were in there pretty tight. Once you remove the two screws, the whole tail light assembly should come off. Mine required a little force and I had to play with it a bit, but it came off without a lot of work. There will be one set of wires that connects the tail light assembly to the rest of the minivan--try not to damage that set of wires. Once you get the tail light assembly off, you'll have to take apart the assembly that actually holds the lights. No tools should be required. It's held on by four plastic catches. Just undo the catches (easier said than done, but still not too tough) and it comes apart. Then you can pop out the old light and pop in the new light. Then re-assemble. For me, it went back together much easier than it came apart.

SOURCE: replace rear wiper motor on ford focus 02 plate

any auto parts store sells a chiltons manual on your ford focus!!! i think they are around $12 dollars it will explain step by step instructions..........................

SOURCE: 2005 Pontiac SV6 Montana key fob unlocks doors but will not lock

For the sliding doors you need to clean the contacts, there are 6 or 8 on both sides, just wipe them clean as they are probably covered in oil/grease/grime.

SOURCE: steps for replacing wiper motor for 1998 VW Jetta

remove wipers. remove plastic covering by loosening plastic screws first. unplug wiper motor wires. there are about three 10mm nuts at the motor location and you also have to unscrew the big nuts that were below the wipers when you unscrewed them. replacement is reversal.

SOURCE: clunking from front end

CHECK FRONT STABILIZER LINK KITS FOR PLAY.
ONE ON EACH SIDE ATTACHED TO STRUTS.