Speedometer and tac gauge does not work. I've checked all of the connections, replaced both censors and all of the fuses. What did I miss? Due to it not working, the transmission isn't reading it and it won't shift properly.

What make , model an year vehicle ? Electrical shorts cause fuse's to blow . Do you know how to read a wiring diagram ? How to use a DVOM - digital volt ohmmeter to test electrical circuits ? If not ,your best bet would be to take your vehicle to a qualified repair shop.

Definitely sounds like a fuse issue. look at the owners manual under fuses. find the location of the one marked "fuel gauge" and check. Usually there are more then one circuit included for the fuse, which may be the other circuits that are not working. If there was recent work done, there may be a loose connection on a terminal going to the distributor.

This is due to a problem with the gears in the speedometer and RPM gauge; there was a manufacturing defect that ford fixed in later years. The cheapest solution is to replace these gauges. I found a local mechanic that knew how to fix it, and did the job for $60. I recommend checking craigslist for a local person, because this is a very common problem. I've also had problems with the fuel gauge, so be aware of any problems with it as well.

your cluster gauge is broken or has a loose connection. if your gauges sometimes work and sometimes dont then it is a loose connection. and if they dont work at all then it is broken. i would also check fuses and electrical supply to gauges. if you dont find any errors or bad grounds then i recommend taking the cluster gauge out and replacing it.

The two gauges work off two different sensors. The tac runs off the crank sensor. the speedometer runs off the speed sensor. Since your car still runs..ie the crank sensor is still good. I would guess that your Instrument panel has shorted. This is just a guess because there are other factors, like wiring that would have to be checked. It is still safe to drive, just watch how fast you are going compared to traffic.

hi because this oly it doesnt work
you can replace that part alone and put a new fuse

could be a fuse for the lites but the speedo might have a bad senser

The connector on the back of the gauge cluster isn't making a good connection. If the speed senser is bad the speedometer won't work either or the fuse the speedometer won't work but if the speedometer does work the trans controller or the shift switch ( park neuurtal drive ) could bemaking abad connection or be full of tans fluild or water (frozen?) The tach not working may indicate a fuse or connection problem to the cluster ( speedometer gauge unit and the computer doesn't know how fast the motor is going) The check engine light should be on in this case and checking for codes and following the repair recomedations for them should find the problem

i have seen and replaced may accord 94-97 gauge clusters for problems like this. most common is the odometer stops working or works erratically. you should check ebay for a gauge cluster

sounds like your missing a ground somewhere.