Multi-information display went out. Cannot locate broken fuse

Have you scanned vehicle got codes?

It is a short in the headlight circuit somewhere after the fuse. I would check first the headlight dimmer switch. They used to be on the floor. I think your model is equipped with a combination multi-function switch on the steering column that controls a relay. I would pull the relay and see if it still blows the fuse to split the possible location of the short in half. If It still pops the fuse it is likely on the multi-function location, and if it doesn't it is likely on the headlight side of the relay.

Bad Miltimeter.

I'm not sure what model Toyota you have, but in a Camry, the cause is most likely a blown fuse. This is a 10A fuse labelled "Gauges" located behind a cover in the dash panel

If you really plan on chasing this one down as a DIY project, you will need electrical diagrams from your car. You can find these and a whole lot of other information here:
Haynes Avalon service manual
Even if you don't care to do your own maintenance, you can get an idea of the potential cost of a repair by looking into the complexity of it before committing to a sky-high repair bill.
We have a Haynes in each of three vehicles and they have saved us time and money.

The IPC displays the season odometer information from the BCM in the driver information center (DIC). The odometer will display an error if the IPC detects invalid odometer data from the BCM.
You'll need to find a 10 AMP fuse in the instrument panel cluster, follow this diagram t locate it: https://ricksfreeautorepairadvice.com/2003-chevrolet-silverado-fuse-diagram/

it sounds like the Multi information display has failed (MID). It is the long display with all the radio controls on it. If you want to find a known good part they are really easy to swap out. Just remove the radio knob and if you look down in there, there is a place to put a T10 (i think maybe bigger or smaller) torx T10 screwdriver.if you turn it while pulling back slightly on the screwdriver it should come right out. It usually is the component that fails but as always you may want to check your fuses.

hi,
I have Toyota Avensis 2005 model. I have a problem with Multi information Display unit. It does not turn off even after switching off the car. The display unit is stuck with a figure. Please help me in fixing this and resetting the unit.
I tried long pressing the ENT button and all the range buttons, but no use - also changed the ODO display.
Thanks,
Raksha.

Oil Change Reset Procedure

1. Turn the "ENGINE START STOP" or engine switch OFF with trip meter A reading shown.
2. While pressing the trip meter reset button, turn the "ENGINE START STOP" switch or engine switch ON.

Without multi-information display

1. Continue to press and hold the knob until the trip meter displays 000000.

With multi-information display

1. Continue to press and hold the knob until "COMPLETE" appears on the multi-information display.