Cannot get the wind shield wiper motor back in the wind shield wiper stops in the middle of the wind shield

check that the wiper arm has not come off the motor crank.

sounds like a wiper motor or might be a bad ground try to tap on the wiper motor with a hamer and is it starts to move you will need to replace it

No, thye should all be on separate fuses.

Wind shield wiper motor has to be replaced, Gears are slipping on it.

Hello, you'll will need to remove wiper motor crouling to get the wiper motor. There will be two rods attached to the wiper motor. Now, this arms operate the wipers on your auto wind shield.
One of the arms have came loose from it ball joint. GB....stewbison

Under the bottom of the outside windshield you will see a grate with slots that let you look down inside. One of the arms connected to the wiper motor must have come loose. Might be as simple as a clip keeping the arm on slipped off and then the arm too. There should be screws to remove the grating in view either if you lift the hood and look on the firewall or even on top on the corners of the grating. You can take that off and get into the wiper motor area. Let me know if this helped and ppppplease leave me a good thumbs up for the effort. I need to keep my score up. Thanks, The Raz Shack

right were the hood ends by the wind shield

check to make sure the wipers are at its right angle on the vehicle, loose the nuts and place both wipers close to the bottom of the wind screen

2 causes wiper switch out or motor bad. Most common is the wiper muti function switch.

Sounds like a linkage (wiper transmission) problem. But, put an external ground wire to the wiper motor first and see if they work then.
Also many wipers have a fastening nut on the wiper arm where it attaches to the stub that goes through the body. These may have loosened and gone out of adjustment. If so, loosen them and re-position arms, then tighten them down.