Where is the blower motor located and is it hard to change ?

Here's a link to what your blower motor resistor look's like,it's next to the blower motor,2 screws hold it on.Blower Motor location can change from year to year. It can change with the trim level of the vehicle. A vehicle that has front and rear climate controls may be configured differently than a vehicle that has front controls only. The following are two different repair procedures. One is given because the blower motor is located and accessed in the engine compartment, the other is given because the blower motor is mounted inside the vehicle. http://www.autozone.com/cooling-heating-and-climate-control/blower-motor-resistor/duralast-blower-motor-resistor/cadillac/deville/1990/8-cylinders-3-4-5l-fi/860043_0_0 Here's a link to your blower motor. GET 35 GIFT CARD FOR EVERY 100 SPENT ON ONLINE SHIP TO HOME ORDERS

The blower motor is located under the Dash on the passenger side. Simply unplug it and unbolt the mounting bolts. The one closest to the firewall may give you a bit of a hard time as the angle is a bit limiting. Does the blower work on any speed? Usually the resistor block goes bad and the blower motor will not work on any speed but high. The resistor block is located next to the motor and it's held in place by two bolts. Good luck!

look under the passenger side of the dash. There will be a plastic trim panel that will need to be removed. Once its out of the way you will see the blower motor. The resistor will be just to the drivers side of the blower motor.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Hi, the blower motor resistor is located inside the duct work where the blower motor goes. There are 3 screws holding it in place, one of which is hard to see.

blower motor resistor is burnt up
located upsteam in air plenum from blower motor
passenger side compartment at foot
locate motor then you should spot resistor close by

Disconnect the negative battery cable.

Disconnect the blower motor lead connector from the wiring harness connector.

Remove the blower motor cooling tube from the blower motor.

Remove the four retaining screws.

Turn the motor and the wheel assembly slightly to the right so that the bottom edge of the mounting plate follows the contour of the wheel well splash panel.

Lift up on the blower and remove it from the blower housing.

Installation the new blower motor by reversing the removal steps.

Connect the negative battery cable.

this is how you do it it's not that hard to do should be at the back under hood on passenger side behind a black cover

sounds like the motor is drawing too many amps. could be from possible blower motor resistor or the blower motor itself.

If the blower moter only works on hi speed it is the blower motor resistor that is bad. The blower motor resistor is located under the passenger side of the dash next to the blower motor. It is not necessary to remove the blower motor to change the resistor.

try the fan relay should be located on the heater box

resistor block is on the heater box usually about even with the mirror...may be hard to see with manifold in the way.