Question about BMW 325

1 Answer

Car will not start. Lever on shifter is stuck in. With key turned on the shifter will move from top to bottom( start, reverse, park, etc.). But, engire will not make a noise. Battery checked out good.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 153 Answers

When is shifter in position D or R engine will not to start. Only in P or N position.
Where is ignition on,shifter will to move. when is ignition off locks shifter in to P positions

Posted on Dec 26, 2010

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 cadillac cts shifter stuck in reverse


on top of transmission you can see the shifter cable remove it from lever. Try to move lever freely try to move the shifter if it stuck again
could be cable or transmission internal
hope it helps

Mar 22, 2014 | 2005 Cadillac CTS

2 Answers

Car wont start and rolls backwards even though it apears to be in park


Sounds like the shifter is stuck in reverse or drive since it will roll.
I would set the parking brake and have someone watch the shift lever on the transmission to see if it and the shifter inside is still connected.

Feb 20, 2014 | 2006 GMC Envoy Denali

2 Answers

Gear shifter is in Park, but dash reads it's in Reverse. Car won't turn over because it is in Reverse now.


You have to locate where the park ignition switch is located. Some are on the transmission and some are in the column under the dash. It probably got moved.

Nov 24, 2013 | 2008 Dodge Caliber

1 Answer

Car stuck in reverse how do I get it back in park


The shifter is connected to a cable that is then attached to a small lever on the transmission. Disconnet the cable at the transmission end and you'll likely be able to physically put it in neutral. Disconnect it at the shifter end and you'll be able to move the shifter to trigger the neutral lockout switch and allow the car to start. You can also short this switch to trick the car into thinking it is in neutral.

Nov 01, 2012 | 2000 Jeep Grand Cherokee Laredo

1 Answer

Elantra won't start and moves when it's in park


I'm going to say something happened to the cable between the shifter and the transmission. There is a switch on the transmission that prevents you from starting the engine in anything other than park or neutral. The transmission is probably in reverse or drive which would allow it to roll.
Someone would need to check the lever on the trans where the shift cable is attached.

Sep 17, 2012 | 2006 Hyundai Elantra

2 Answers

2006 chrysler pacifica - drove car into my garage and shut down. Next morning I could not get the car to shift out of park.


some are set up with safety with brake lites out. ck if brake lites work if not turn key on do not start and shift to neautral and start and have brake lites repaired

Jun 03, 2011 | 2006 Chrysler 300

1 Answer

Chrysler concorde car wont shift from reverse to park


it sounds like your gearshift cable is broken..if you can jack up vehicle and support it safely,get someone to move shifter and look on driver's side of transmission and see if linkage is moving on trans..linkage is up near top of trans..i have seen this problem before

Jul 30, 2009 | 2000 Chrysler Concorde

1 Answer

Key rotates but shift stuck in park. Windows and locks do not work, cannot start car.


Getting a Saturn L series with Automatic transaxle out of park to neutral is pretty easy. It is desribed in the owner's manua for my 2001 LW 6 cyl. Here is how it goes.

The plastic cover plate that indicates what Shifter position you have selected ( P R N D etc.) will pop loose with just a small screwdriver inserted at the top end (radio end) and pried gently. Once the plate is loose, locate a white plastic lever in the back section of the shifter hoiusing. Pull this white lever and the shifter will be freed to put in whatever position you desire.

Happy shifting!

Jul 27, 2008 | 2001 Saturn Lw 4dr Wagon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

174 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

auntyjack

Level 2 Expert

104 Answers

Roy Cunningham

Level 1 Expert

35 Answers

vince

Level 3 Expert

1234 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...