I don't have a diagram, but the filter is on the driver side in front of the rear wheel. In between the gas tank and the frame you will see a black plastic cover about 12 inches long. Pop off the cover and you will see the filter. Very simple to change, just push on the blue clips and pull the lines off, be prepared for some fuel.
SOURCE: how to relieve the pressure on the fuel system in
look for the fuel rail, it should be the chrome pipe that runs between all of the injectors, there should be a plastic cap that you can unscrew and under it should be the pressure check port, it looks like a regular tire valve, with the ignition key OFF push the valve in and the fuel pressure will be released, fuel will also be released so be sure you have a rag handy, and don't look into the valve when you push it
SOURCE: can't get my fuel filter to go back on correctly
compare filters , make sure they are the same {not close} slowly rotate filter as u install it ,it should drop in ,atleast mine does . sorry dont have any pictures . good luck....
SOURCE: 2003 Ford Expedition, low idle, no power while driving.
sounds like water in gas. add gas line antifreeze. 2 bottleshould do it.
SOURCE: How to change the inline fuel filter on a 2003
You need a quick release tool sold at the auto parts store,just slide the tool over the line,and push it in the filter,and pull on the lines,and they will release,then to install,just push the lines in the filter until they click,if this was at all helpful,please rate thank you.
Testimonial: "Very quick easily understood "
239 views
Usually answered in minutes!
×