-
Master
1,547 Answers
- Posted on Dec 20, 2010
Re: How can i fit engine belt of hyundai azera 2009
Find the tensioner. The serpentine belt tensioner is what
holds the belt in place with the correct tension: it is held to the
engine by two bolts. Some describe the Hyundai Sonata tensioner pulley
as attached to a teardrop shape, with the bolts holding the structure to
the engine.
2
Remove the two bolts near the tensioner with your wrench (bolt size may vary by model). Take off the tensioner and the belt.
3
Use a belt routing diagram or your own sketches to replace
the serpentine belt. This is helpful for some models: from the power
steering pump, the belt goes to the left of the idler pulley, then over
and around the right side of the air conditioner compressor pulley, around the left side of the crank pulley, to the right of the tensioner pulley, and down to the alternator.
4
Replace the tensioner and the new belt together. Mechanics
recommend seating the belt on the tensioner before replacing the
tensioner onto the engine rather than trying to pry the belt over the
pulley.
5
Tighten the two lock bolts that hold the tensioner.
6
Check to see that the belt is seated correctly on all of the
pulleys. Run the engine and observe to check for proper installation.
×