2002 chevy blazer good into 4 x4 but seem not in gaged

I just replaced the fuel pump on my 2000 ZR-2 blazer and the fuel sensor was made on to the pump. It is in the gas tank. It is a flotation type device. You have to drop the tank, turn the lock ring counterclock wise pull the unit and replace it.Be careful installing it because if you bend the plunger rod it will not read correctly

ok iif the instrument cluster does not work.. before i give a solution can you tell me if it have atach and temp gage not a temp gage witha idiot light but a actual temp gage.. because if temp gage and fule gage hands are not in their proper place like if yo uhave a 1/4 tank of gas and it reads way past full and the temp gage is gone out of site way past say 240 degrees then it is your speedo head .. have this trouble the other day on a chevy 2002 cavalier.. replaced the head and wahla the car started. it seems the speedo head is tied in with the computer system on these cars.. and if the tach is not working you need not worry if you cannot find a head with a built in tach.. a normal speedo head with out the tach part will also work.. just when you change the head count the pins on the old one and compare it to the new one if they match then just plug it in and car should start..

Did you check the coolant temperature sensor if it thinks the engine is overheating it will shut the engine down.

Here's a link to the wiring diagram for the 1997 Chevy Blazer.

its a problem with your sending unit most likly. its in your gas tank and tells your gauge how much gas is in your tank. I had a chevy truck and a blazer and both of them had this problem. I believe its a problem with all chevy models in my opinon. I would most definatly say that its your sending unit.

might want to check your transmission

There is no reset, if you need to change from Farenheit to Celius, press the power button to cycle thru. If you are seeing an OC in the display, that means there is an open connection in the sensor wiring most like at the sensor connector under the hood.

heres a diagram 2000 s10 blazer 4.3 engine, hope this helps.

approximately 5 litres

usually two screws one at the armrest and one under the power window console , this console usually pops out to let you at the screw.