If the problem has been repaired than the light will go out automatically. If you have not repaired the problem the light will not go out even if you try to clear the codes with a scan tool.
Your best bet is to scan the ABS module with a scan tool and find out what codes are stored. Then you'll have a much better idea of what the problem could be.
I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa
Most vehicles that display Warning lamps DO NOT clear or turn off Safety System(s) warning lamps. They MUST be cleared with a scanner. Other NON-Safety warning lamps WILL clear themselves after the problem has been corrected, and the computer runs its next diagnostic scan.
SOURCE: How do you reset ABS light\system after replacing
turn the ignition to on position and disconnect one of terminals of battery for 30 sec to one minute and reconnect battery . turn off ignition and restart vehicle . If that doesn't work go to dealer .
SOURCE: power steering pump Ford Focus 2006 DIY Manual
its quite quite simple;take your pipes of and block them off reconnect them to new pump and replace pump to in line belts.adrian;;;
SOURCE: abs light on car has been to ford dealer problem
If you paid good money to have it fixed at a FORD AGENT then take it back and tell them that you are going to wait for it and dont take any **** from them as all work done by a Ford agent will be under warranty so if its still in warranty time take it back, or tell them your take it to the papers and let them tell the world..
It works belive me.
Let me know how you get on . RON
SOURCE: my abs light stays on on my ford focus
when the ABS light stays on it means there is a fault present in the ABS system and the ABS has been disabled, as long as the light is on u just have regular brakes with no ABS, there are many thinbgs that can turn the light on, most common is one of the wheel speed sensors is defective, since these sensors are about $75-100 each and there are 4 of them guessing is a poor idea, so what u need to do is have the ABS systwem tested, there will be a fault code present to help narrow down the defective part or wiring.
SOURCE: ford focus has the ABS brake light on and traction control light
chek the brake fliud level. if low light will set light and abs wont work.
3,347 views
Usually answered in minutes!
×