Question about 2000 Ford Crown Victoria

1 Answer

Running hot. heater does not work sometimes. acts like the therostat is sticking

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 61 Answers

So change the thermostat and see what happens.

Posted on Feb 23, 2011

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 jeep grand cherokee heater blowing cold air


thermostat probably sticking.. is the temp running normal or cooler than normal

Dec 28, 2013 | Jeep Cherokee Cars & Trucks

1 Answer

List of things i've tried already


you should have called a mechanic long time ago sounds like might be water pump .you might have a blown head gasket too

May 13, 2013 | 1991 Honda Accord

1 Answer

Running hot


For car running hot problem,i suggest you to click this link below and follow the troubleshooting procedure:-----http://technoanswers.blogspot.in/2012/02/car-running-hot.html
-----------Thanks.

Feb 09, 2012 | 1991 Lincoln Town Car

2 Answers

No heat changed therostat and blower motor works still no heat ?


if the cooling system is full and the car is at operating temperature then it sounds like you may have a blocked heater core.with car at operating temperature touch the heater hoses they should both be hot.if one hose is hot and the other is cold then the heater core is blocked and will need to be replaced.

Apr 05, 2011 | 1996 Nissan Maxima

1 Answer

2000 ford escort therostat not working right


Replace the thermostat first. Make sure the antifreeze level is full. Bleed the system. most car's have a bleeder valve located at the thermostat housing outlet.Drain the coolant level only to below the thermostat where it won't leak when removing the housing and thermostat. If it's the heater core it is located under the dash where the 2 heater hoses enter the cab from the engine compartment.

Jan 22, 2009 | 2000 Ford Escort

1 Answer

No heat from heater on 01 sonoma x cab


therostat stuck , or add anti freeze to reservoir if low

Jan 03, 2009 | 2001 GMC Sonoma Extended Cab

3 Answers

2002 mercury sable heater wont get hot


you have a broken or stuck temp blend door in the heater case. or the servo motor is broken. this sits on top of the heater case

Dec 02, 2008 | 2001 Mercury Sable

1 Answer

Running hot


replace the therostat ( most likely )

and the radiator cap

Nov 29, 2008 | 2002 Pontiac Aztek

1 Answer

Heater problems


Did you bleed the air oout of the cooling system - Their is a bleeding next to the therostat housing.


1 - When the vehicle is cold remove the rad(tank) cap and top up the level if needed

2 - start the vehicle with the rad cap off and leave the car run until you can see that the therostat has openned(look in tank/rad) to see fuild flow then open the bleeder slowly to let any air out of the cooling system. Once you have coolant flowing out of the bleeder close the bleeder and install the rad/tank cap.

NOTE - Be careful with the engine running and hot Coolant.

You make need to bleeding system 2-3 time to get all the all out. Once all the air is out of the system you problem should be solved. If air returns to the coolant system have the system checked for possible head gasket leaking air into the coolant system

Nov 19, 2008 | 1997 Dodge Intrepid

2 Answers

2002 V.W. Jetta 2.0 liter overheat


turn your heater on to max heat and high fan. then see if you can feel the hoses on the firewall for heat they should be hot. make sure that the fan unit on the radiatoris working if the upper radiator hose is hot the fans should be running if they are not that means that either the relay is bad the thermo sensor is bad or the fan unit is shot... please rate the solution..........thanks

Sep 24, 2008 | 2002 Volkswagen Jetta TDI

Not finding what you are looking for?
2000 Ford Crown Victoria Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...