Sounds a lot like the fuel pump for a starter. When it acts up does the vehicle jerk or buck before picking up speed? I have also had the experience with just one spark plug wire or plug bad. You can check this by pulling each wire one at a time while engine is running. If the motor slows that plug and wire are fine. If no change in rpm check the plug and wire.
SOURCE: my truck blows white smoke
Hello!
There are two differnt reasons for black and white smoke coming from the tail pipe.
Black smoke means fuel runs rich (car getting to much gas). Check fuel pressure/air filter.
In some cases the white smoke means car is burning oil or transmittion fluid. Have tem checked/replaced.
If you can feel a smelly smoke it can be catalytic converter.
In a worsest scenario if car blowing white smoke it can be engine coolant is getting into an engine cylinder from a bad head gasket ,or a warped/cracked head. So you need to keep your eye on coolant level and check your engine for overheat. Also might be good to check your oil for traces of coolant (on a dipstick it would be a milky substance mixture of oil and coolant).
Good Luck
SOURCE: My f350 transmission will not shift unless you
check transmission fluid level.if level okay.look at tranny fluid.if it look dark and smell real bad change filter and fluid.
SOURCE: 2005 MUSTANG GT SPEEDOMETER JUST QUIT WORKING
Could be a fuse my old sunbird would tell me it was going 60km an hour at a dead stop and when i started moveing it would drop to 0 replaced ALL the fuses and had no more problems
SOURCE: Won't start. Starter is good. 99 Crown Vic
If the battery is good,have it checked,then the cables,or there connections are bad,make sure the connections are shiny clean,on the battery post,and the cable ends,side post connections on battery need to be clean also.If the connections are clean,like this,then the cables are bad,either ground,or positive,or both.When trying to crank the engine,while it is being turned over,feel of both cables,witch ever one heats up,is bad.You may have to remove fuel pump fuse to keep it from starting,so that you can do this test.
SOURCE: how do i replace oil pump on 2002 ranger 4 x 4
engine size?
4.0L
Removal and Installation
NOTE: Inspect integral oil pan gasket for cuts or damage that may cause leaks. Install a new gasket if necessary.
NOTE: Fill the engine with clean engine oil.
To install, reverse the removal procedure.
188 views
Usually answered in minutes!
×