Is it diesel or gas, you could have from what you described a leaking head gasket as that would cause it to blow smokethat would also cause the loafing as water would be getting into the cylinder
If you need further help, I’m available over the phone at https://www.6ya.com/expert/randy_598ee00c65056cc9
SOURCE: 2003 F350 Intrument Cluster
If everything keeps going like that then it sounds like its a problem with the onboard computer. The computer controls all the guages and would explain why they all fail at the same time.
SOURCE: F350 Super Duty Diesel 2005
I had the same problem with my '05 F350, it's the Fuel Injection Control Module (FICM). My dealer replaced it under warranty, and even picked up the tow!!!!!!!!!
SOURCE: front wheel bearing removal on 2006 F350 touchtone 4X4
Get a good repair manual. Front ends on 4X4s require proper care.
SOURCE: fuel leaking from ford f250 1999 super duty v8, 7,3 truck
check the high pressure return line behind the fuel filter the clamp securing it will vibrate and rub a hole in the line. i was quoted a couple of hundred to replace the line, i put a small piece of fuel line over the hole and secured it with a worm gear clamp. no leaks in over 2 years
SOURCE: Shut 05 Ford f350 diesel off wont start
dies the truck restart once it cools off? it is very common for th 6.0 to have high pressure oil issues on a hot soak. they will run till the cows come home but once shut off they can not build up enough pressure by cranking speed alone to start truck until it cools down and the seals become rigid enough to bridge the gaps they are sealing in the first please. if this is the case. it may be the STC fitting ojn the back of the high pressure oil pump (intake and turbos must be removed to check) or possibly the branch tube o rings have worn. the branch tubes are located under the valve covers and supply the fuel injectors the oil they need to perform their "power stroke"...
53 views
Usually answered in minutes!
×