SOURCE: Isuzu Rodeo abs light
I had it repaired: one of my sensors needed to be replaced. No more light!
SOURCE: Failed Smog Test - 4 codes for 2001 Isuzu Rodeo
Tune it up and replace the 02 sensor that keeps setting the codes bank 2 sensor 1. Have your oil and filter changed right before you go for a retest to. That will clear up 3 codes P0300, 0155 and 0154. You might have to replace the fuel sending unit to get rid of P0463 but if the gauge works OK I'd leave it alone.
SOURCE: 2001 isuzu rodeo has intermittent starting problems
check battery cables & terminals for tightness & corrosion.also check at starter.check starter bolts & actual starter for looseness.if no problems found your starter may be on its way out.next time it happens hit starter with hammer or heavy object if it starts right up get ready to replace it.good luck
SOURCE: Were is my ABS sensor located on my 2000 Isuzu Rodeo
there should be a sensor at all 4 wheels so make sure there all pluged in
SOURCE: Crank Sensor in 94 Isuzu Rodeo
it's on the bottom of the motor, towards the back on the passenger side. It has a small clip of wires and one screw holding it on. You may want to pull it up on ramps- if it'll run- otherwise, get under the Rodeo, it's up a little higher than the oil pan, and to the passenger side. (it's right on top of the two lines that run to the bottom of the radiator.) You will need a 10mm socket to remove it. I have added a few pics showing the location (i just completed this task myself)
565 views
Usually answered in minutes!
×