Question about GMC Yukon

3 Answers

How do i put my 4x4 on my 95 yukon......on park or neutral. and do i have to put my foot on the brake?

Posted by on

Ad

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 518 Answers

With foot on brake,shift into neutral,then engage either 4 wheel high or low depending on your conditions. Remember you should not drive faster than 40 mph in either 4 wheel. When you want to shift back into 2 wheel,foot on brake then into neutral & back into 2 wheel.

Posted on Dec 06, 2010

Ad

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 7 Answers

Yukon should be the floor shift 4x4 put the vehicle in neutral and shift into 4x4 wait a few seconds and the light should come on.. if it doesnt come on put the vehicle in drive let the vehicle roll forward a few inches and put back in neutral .. you might have to do this a few times to get it to work ... also go from reverse to neutral if it doesnt work then the compnent on the front axle is usually bad ..

Posted on Dec 06, 2010

Ad

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 4,669 Answers

You can shift between 2Hi and 4Hi when the truck is moving. Just let off the gas and shift it. But in order to shift to Neutral or 4Lo you need to stop the truck and shift the transmission into neutral then shift the transfer case.

Posted on Dec 06, 2010

3 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Anonymous

  • 275 Answers

SOURCE: 93 GMC Yukon wont stay running

Put some lucas fuel system cleaner in the fuel tank check the plugs and wires and check the air filter and see if there is a bad smell like rotten eggs when you first start it. does it use a lot of gas

Posted on Nov 12, 2008

Greg Stefan

  • 462 Answers

SOURCE: put foot on brake car wont shift out of park

Check brake light switch.

Posted on May 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car is running , can't put gear into park , will it restart if in neutral once I turn motor of?


try making sure you have your foot on the brake pedal, some cars won't come out or go into park without having you brake pedal depressed, if this fails you should see a specialist, most auto cars will start in neutral depending on age, but MAKE SURE THE HAND BRAKE IS ON HARD, good luck.

Mar 16, 2015 | Cars & Trucks

1 Answer

2005 yukon will no go in to park


Put foot on brake push shifter all way up. Lol. Seriously of it doesnt go into park your transmission is messed up. Teeth likely broke inside blocking the shift ability. Not common at all. If someone slammed it into park while driving could cause this.

Jul 20, 2014 | 2005 GMC Yukon

1 Answer

2002 T&C 3.8L intermitten starting


You would need to check the neutral safety switch for power in park and neutral going to the starter.

Feb 24, 2013 | 2002 Chrysler Town & Country

1 Answer

Shifter sticks in park


when parking put into neutral put on the hand brake and take your foot off the brake allowing the car to settle against the brake then put it into park, this should eliminate the sticking in park as the cars loading the brake not the transmission

Mar 24, 2012 | 2005 Pontiac GTO

1 Answer

Truck will not shift out of 4 wheel low.


To shift out of low, you need to be stopped, you need to have it in neutral, and have your foot on the brake.Foot on brake and transmission in neutral,then try to shift out of 4 wheel low. ---------- try this.Keep updated.Thanks.Helpmech.

Feb 04, 2011 | 2000 GMC Yukon XL

1 Answer

The parking brake in my chrysler pacific is stuck. how do u release it?


Is it a "stick" in the console between the driver and passenger seats, or is it a pedal you push down? If it is in the center console, try starting the car, putting it from park into NEUTRAL with your foot on the brake, and pull up on the stick a little while pushing in the button. If the button goes in, push the handle back down, put the car back into park, and take your foot off the brake. I'm not real familiar with the Pacifica, so a description of the parking brake would help.

Nov 18, 2010 | Chrysler Pacifica Cars & Trucks

1 Answer

Mazda 6 won't start; battery is ok & headlight is ok


Test the neutral switch.

===

Foot on brake

MOVE SHIFTER BACK FROM PARK AND NEUTRAL 10-20 times. This will re-new the metal contacts.

Shift to netural "N"

Start engine

Put lever back to Park "P" to warm up the truck.

====

If it start from neutral and not park then you will need a neutral safety switch.


Please rate my answer if it's helpful to you.

Cheers,

MUSTGO

Dec 14, 2009 | 2004 Mazda 6

1 Answer

I replaced transmission and now car dont start


Test the neutral switch.

===

Foot on brake

MOVE SHIFTER BACK FROM PARK AND NEUTRAL 10-20 times. This will re-new the metal contacts.

Shift to netural "N"

Start engine

Put lever back to Park "P" to warm up the truck.

====

If it start from neutral and not park then you will need a neutral safety switch.


Please rate my answer if it's helpful to you.

Cheers,

MUSTGO

Dec 14, 2009 | 1998 Cadillac Catera

2 Answers

Wouldn't ome out of park. possible neutral safty swich


sounds like the shifter interlock solenoid is not working..when you put your foot on the brake,there should be a click. there is a tab in the shifter assembly that can be pried out.it is a shift lock override. you can put the key down inside and get it out of park.that is there so in the case of a dead battery,the car can be put in neutral.

Oct 23, 2009 | 1995 Nissan Sentra

2 Answers

93 GMC Yukon wont stay running


Put some lucas fuel system cleaner in the fuel tank check the plugs and wires and check the air filter and see if there is a bad smell like rotten eggs when you first start it. does it use a lot of gas

Nov 12, 2008 | 1997 Chevrolet S-10 Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

394 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...