After an oli change my 2005 Isuzu Ascender did not start, fuel pump was replaced and a sensor was replaced. It started for 10 minutes and after I stepped on the accelerator the vehicle turned stalled and never started again.
Disconnect the battery cable, either one pos or neg. wait 5 min and re-secure the battery cable and be sure to tighten to post(s). By disconnecting and re-attaching, you are re-setting the computer. If problem persists, check the work that was done, make sure all bolts and attachments are secure. good luck
6 long years old ,id bet it sold now.
×
Wow i dont know where to start... when was the fuel pump replaced, had you ran it sense?? because the newer vehicles need to teach themselves how to idle, shift and everything all over again if you take the battery cable off. as far as not starting are you sure that the fuel pump is running?? and what was the sensor you replaced?? if i had a little more info i could help you a little better
251 views
Usually answered in minutes!
The pump is running and after the 2nd fuel pump was replaced it ran for a few minutes. The knock and crank sensors were replaced.
×