Transmission slipping? Transmission will not shift into second gear unless I let off the gas. Otherwise engine races. Cruise control stopped working when this problem started. Transmission works fine otherwise. Lumina 3.1 sedan, 1997

There could be several reasons why your 2005 Dodge Magnum is experiencing problems with shifting from second to third gear and then suddenly hitting reverse, including:

1. Transmission Fluid Level: Low transmission fluid level can cause erratic shifting, slipping, or stalling in your vehicle. Make sure to check your transmission fluid level and add if necessary.
2. Shift Solenoid: A faulty shift solenoid can cause problems with shifting in your transmission. The solenoids control the flow of transmission fluid through the valve body, which controls the shifting of gears. If the shift solenoid is failing or has failed, it can cause the transmission to slip, shift erratically, or get stuck in a gear.
3. Transmission Pump: The transmission pump is responsible for pumping transmission fluid through the transmission and to the torque converter. If the pump is failing, it may not be able to pump fluid properly, leading to problems with shifting and slippage.
4. Valve Body: The valve body controls the flow of transmission fluid through the transmission and directs the shifting of gears. If the valve body is failing, it can cause the transmission to shift erratically or get stuck in a gear.
5. Transmission Control Module (TCM): The TCM is responsible for controlling the transmission's shifting and overall performance. If the TCM is failing, it can cause the transmission to shift erratically or get stuck in a gear.

It's best to have a qualified mechanic diagnose and repair the issue as they will have the necessary tools and expertise to properly diagnose and fix the issue.

run the fault but all you describe is operated from the VSS sensor ( vehicle speed sensor)
it tells the cruise control the vehicle speed , tells the TCM the vehicle speed so that ratios can be changed, activates the speedo,and will report with a check engine light to report a transmission problem
run the fault codes first

Transmission slipping, doesn't ingage it slips but like you said it will do so

that is a hum dinger, largest ever posted, in one shot.
very good.!
one word , the transmission slips. (never drive a slipping tranny)
overheat indicator.! that is key.
many newer cars will change the transmission shifting any time
the engine over heats.
and overheat wins over transmission , every time.
if the engine burns up, what good is any transmission.? nada.

solve overheat first.

slip or flare.
is when the engine RPM rises fast and the car dont go faster.
SLIPS.
and slipping burns up trannyclutchs and increases the damage. inside the transmission, dont do that. dont allow it,
park it and fix it.

on some tranny there is a temperature sensor that the TCM
watches and changes shift patterns based on AFT fluid temps.
and if the ATF fluid gets too hot , it takes actions. to keep the tranny from harm.

why not get a scan too and see what DTC errors there are..
DTC, engine overheate.
DTC< tranny overheat (caused by above)

Jour clutch and felfbody is the problem and u need to rebild jour gear box sory

P0732 FORD - Incorrect Second Gear Ratio
Transmission in second gear and the ECM detected an incorrect gear ration. This diagnosis monitors actual gear position by checking the torque converter slip ratio calculated by Transmission Control Module (TCM) as follows:

Torque converter slip ratio = A x C/B

A: Output shaft revolution signal from revolution sensor
B: Engine speed signal from Engine Control Module (ECM)
C: Gear ratio determined as gear position which TCM supposes

If the actual gear position is higher than the position (2nd) supposed by TCM, the slip ratio will be more than normal. In case the ratio exceeds the specified value, TCM judges this diagnosis malfunction.

Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- Incorrect transmission shifting

Possible causes
- Low transmission fluid level
- Dirty transmission fluid
- Shift solenoids
- Transmission mechanical problems
- Transmission hydraulic control circuit

Tech notes
Start by inspecting the transmission fluid level and condition, and change fluid if necessary.


Hope helps.

You should not use overdrive unless you are steadily going highway speeds. I had one of those and my ex liked to use cruise control on windy coastal roads. This caused it to shift back and forth from 3rd to overdrive constantly. So I disconnected the cruise control so he couldn't use it. Lol. I'm not suggesting this for you. You should keep overdrive off for now and have your transmission serviced. New filter & oil & flush the cooler. Make sure you ONLY USE THE RECOMMENDED FLUIDS!!!!!!!!!! See if that helps. Do not use overdrive pulling a trailer and going up a hill and do not use it if you are on windy roads where you are slowing down alot of times. Try letting off the gas for a second when you do want to engage the overdrive. Remember to always check your automatic tranny fluid with the engine running and fully warmed up.

I’m happy to assist further over the phone at https://www.6ya.com/expert/kim_3202917d7c587455

try replacing the fluid and adding some LUCAS brand stop slip to the fluid also check the transmission mount and motor mounts

It is possible that the computer is the culprit. Most cars with computer controlled trannys will keep in 3rd gear and only shift to overdrive when the engine has warmed up sufficiently. It could be a problem with this system. The best place to take it is your local AAMCO or Mr. Transmission, or the dealer. A regular garage will just be guessing in some cases unless the problem is revealed after running the engine codes.

I also have a 2009 Outlander Sportronic transmission with a V6 engine.
Bought it this summer ... transmission appeared fine but seemed to automatically slow down the vehicle using the engines compression whenever I let go of the gas pedal.
Now that the cold weather is upon us here in Canada, whenever I accelarate normally (not like a teenager) the transmission takes quite a bit of time to shift into second... If I rev up the engine (quick take off) it seems to help but the shifting of gears is not as smooth as I would expect it (mildly slips and kicks into second)...

The worst is when come to a complete stop ... then the transmission kicks coming down from the higher gears???

I read somewhere that this is because this transmission is a CVT type and is learning my driving habits in order to adjust itself so the vehicle becomes more fuel efficient... Not sure but if the trany is computer controlled then it must be poorly writen program...
I'm taking the car in to the dealer and will write back on the diagnostic they give me ...