Need to remove the door panel - 2004 Buick Park Avenue

Click the link below:-----Door Panel Removal?

--------
How to remove the door panel to install a new window regulator?
http://howtobyme.blogspot.com/2011/08/how-to-remove-door-panel-to-install-new.html

---------
Hummer H2 Door Panel Removal? http://technoanswers.blogspot.in/2012/07/hummer-h2-door-panel-removal.html Hummer H2: How to remove Front Door panel? http://www.howtobyme.blogspot.com/2012/07/hummer-h2-how-to-remove-front-door.html 2009 Hummer H2 Door Panel Removal http://schematicsdiagram.blogspot.in/2012/07/2009-hummer-h2-door-panel-removal.html

-----------
how to remove window motor on driver side door panel?
http://technoanswers.blogspot.com/2011/08/how-to-remove-window-motor-on-driver.html

-----------
ford explorer window motor, regulator and door panel removal?
http://technoanswers.blogspot.com/2011/02/ford-explorer-window-motor-regulator.html

---------
Keep updated for more help.

Its simple its fitted by screws,that you need to remove,then pry the panel oiut with small putty knife.Take care no electrical connectors gets pulled off ot cut off.

There are few help links to complete this task of removing door panels.Click the link below:---



How to remove the door panel to install a new window regulator?
http://howtobyme.blogspot.com/2011/08/how-to-remove-door-panel-to-install-new.html



----------
window motor, regulator and door panel removal?
http://technoanswers.blogspot.com/2011/02/ford-explorer-window-motor-regulator.html

-------------
How to Remove Door Panels ?
http://repairhelpcenter.blogspot.com/2011/11/how-to-remove-door-panels-on-acura.html

---------

How to Access car door panel?
http://howtobyme.blogspot.com/2011/11/how-to-access-car-door-panel.html

-------

Vehicle door panel components?
http://howtobyme.blogspot.com/2011/11/vehicle-door-panel-components.html

-------
This will help.
Thanks.

• 
  

1. Remove the front door trim panel.
   

1. Position aside the front door watershield to gain access to the exterior rear view mirror control switch electrical connector.

4.Disconnect the exterior rear view mirror control switch electrical connector

as you see you have to remove the door panel to have access to the electrical connector in case that you dont know how to do it here are the instructions

NOTE: Left front door trim panel shown, right front door trim panel similar.

1. Remove the sail panel.
   
   • If equipped, disconnect the electrical connector
   
   
2. If equipped, lift up and remove the exterior rear view mirror control switch panel.
   • Disconnect the electrical connector.

1. If equipped, lift up and remove the window control switch panel.
   • Disconnect the electrical connector.

1. If equipped, remove the window regulator handle.
   1. Position the window regulator handle cover aside.
   1. Remove the window regulator handle screw and regulator handle

5.Remove the door trim panel center screw cover
6.Remove the 2 door trim panel center screws
7.Remove the 2 door trim panel lower screws

1. NOTICE: Do not pull directly outward on front door trim panel as damage will occur.
   Remove the front door trim panel.
   • Lift upward to remove the front door trim panel.

1. NOTICE: Insert the lower panel tabs first or they can break when installing the front door trim panel.
   To install, reverse the removal procedure

YOU NEED CLIP REMOVAL TOOL TO REMOVE WINDOW CRANK HANDLE.YOU NEED DOOR PANEL FLAT TOOL REMOVE DOOR PANEL HATE TO SAY DOOR PANEL HAS AT LEAST 8 CLIPS LOCATIONS 4 CLIPS AT THE BOTTOM PANEL 2 CLIPS ON BOTH SIDES DOOR PANEL. YOU HAVE TO REMOVE 2 SCREWS HOLDING DOOR PULL CUP.YOU HAVE RELEASE CLIP BEHIND DOOR HANDLE USING TRIM TOOL.IF YOU HAVE TROUBLE GETTING DOOR PANEL OFF.HAYNES REPAIR MANUAL CAN HELP.

hello here is the instructions for removing the door panel.

Remove the door handle bezel.

Remove the window handle,.

Remove the power accessory switch panel.

Remove the trim panel upper extension

Remove the trim panel screws.

Remove the courtesy light,

Remove door panel screws.

Remove the trim panel from the door, carefully sliding the trim panel up to release the retainers from the door.

Remove the speaker wire.

remove the door panel the 3 nuts are located under the panel then a electral conector need to be disconected the trickey part is removing thr door panel behind the door handle the one you use to open the door is a panel tht you need to remove the you will se screws remove them now you need to remove thepower window switch panel BEE CARFULL I HAVE BROKEN THIS PANEL take a small flat screw driver or a putter knife insert and lift the rear of this panel or it may be the front of this panel i do not rember one end or the other will lift out now remove the scres that hold the panel to the door pull the bottom of the panel out this may come hard when you get it out lift the door panel up now you see what you need to do

1. If equipped, remove the window crank handle by using a retaining clip removal tool.
2. Remove the door handle bezel by inserting a flat trim removal tool between the door panel and handle bezel to release the locking tabs.
3. Remove all door panel electrical connectors .
4. Remove the door panel push pins and trim screws. Lift the door panel up and out to release the door panel locking tabs.

For a 1999 Ford Econoline 150 (assume the same or very similar), remove triangular plastic cover over mirror assembly by prying straight out, remove plastic door handle cover by prying up from the front side, remove electronic door switches by prying up from back side, remove round plastic cover at bottom rear of door panel. Four screws are now revealed, remove them. Lift door panel straight up, clips are hooks (not snap in). Work door switch assembly out of door panel. Set door panel aside. Reassemble in reverse order.

please rate if this helps. Section 01-05: Trim, Interior 1995 Thunderbird, Cougar Workshop Manual REMOVAL AND INSTALLATION The interior trim component Removal and Installation procedures generally apply to all models. If some of the steps do not apply to the particular models being serviced, proceed to the next step. Trim Panels, Door Removal and Installation

1. CAUTION: Do not pry front door trim panel (23942). Prying on front door trim panel will break the hook retainers.
   Disconnect battery ground cable (14301) .
   

1. Carefully pull front door trim panel finish panel (23712) away from front door trim panel .
   
   
   
   
   

Item Part Number Description 1 23713 Front Door Trim Panel Finish Panel 2 17B676 Outside Rear View Mirror Control 3 14028 Door Lock Switch 4 55928-S55 Screw (5 Req'd) 5 14529 Window Regulator Control Switch 6 23942 Front Door Trim Panel

1. Disconnect wires from front door lock switches (14017), outside rear view mirror controls (17B676) and window regulator control switches (14529) , if equipped; remove front door trim panel finish panel.

1. Remove front door trim panel retaining screw through front door trim panel finish panel opening.
   
   Trim Panels, Door
   
   
   
   
   
   Item Part Number Description 1 20124 Front Door 2 23942 Front Door Trim Panel 3 383356-S100 Nut (2 Req'd Each Side) 4 56903-S58 Screw (2 Req'd Each Side)

1. Remove interior lamp lens cover.

1. Remove screw through interior lamp opening.

1. Slide front door trim panel upward to disengage hooks.

1. Rotate top of front door trim panel away from front door (20125) , and lift bottom hooks from front door.

1. Disconnect window regulator jumper wire (14A630) .

1. Remove front door trim panel.

1. To install, reverse Removal procedure.

Depends on what door trim you are trying to replace. If you are trying to replace the door trim on the front doors you need to remove two screws from behind the casing around the door handle and then remove a screw from the bottom left of the door and then there will be a screw on the left of the door as high as the arm rest on the door. Finally pull up on the door panel and out to remove the panel. Remove the harnesses and you are complete.

If you are trying to remove the rear doors you need to remove a screw from the bottom of the door again near the left side then remove the screw from behind the casing that surrounds the door handle. Finally pull up on the door panel and out to remove the panel. Remove the harnesses and you are complete.