SOURCE: change oxygen sensor 2001 ford windstar
fist unclip wire,then unscrew it with a 28mm spanner ,fitting procedure is the reverse .It turns anticlockwise to unscrew and clockwise to screw up ,torque setting is a grunt and two scuffed knuckles and max of 3 swear words
SOURCE: ford windstar van, 2003
I had a small plastic piece replaced in the transmission and it solved the problem(2007). My car was still under warranty, so it only cost me about $100.00. The actual cost was closer to $900.00 because of the labor involved. I used the Ford Dealer in Schulenburg, Texas. They would know exactly what you are talking about, if you ask them.
SOURCE: Driving a 2003 Ford windstar. Went to pass and
Very common on this make and model trans, pump drive splines inside torque converter strip out and pump is not turning, Most times there is no damage to pump shaft. Remove trans and remove torque converter, inspect the splines at the very bottom of the hub hole. If stripped out inspected pump shaft splines which are the smaller center splines coming out of trans, if ok replace torque converter and re-install trans, change out fluid, clean any metal from magnet and replace filter, fill with fluid and verify proper operation.
SOURCE: 1999 ford windstar.
replace VSS (speed sensor) and/or TRS (range sensor) use a DTC reader to confirm
87 views
Usually answered in minutes!
×