P0732 Nissan - 2nd. Gear Malfunction
Possible causes- Low transmission fluid level
- Dirty transmission fluid
- Faulty Shift Solenoids
- Shift Solenoids harness is open or shorted
- Shift Solenoids circuit poot electrical connection
- Transmission mechanical problems
- Transmission hydraulic control circuit
P1448 Nissan
P1448 Nissan - EVAP Canister Vent Control Valve Open
Possible causes
- EVAP canister vent control valve
- EVAP canister is saturated with water
- EVAP control system pressure sensor and the circuit
- Blocked rubber tube to EVAP canister vent control valve
- Water separator
The EVAP codes you are getting are directly related to your
\'
vent control valve\'. This is VERY COMMON on this generation
Maxima. Up under yer car behind the left rear wheel is your
EVAP canister. (black plastic box) Your
vent control valveis
bolted directly to this canister, with 2 screws. There should
be a vacuum line connected to it. Be sure it IS, and that it
looks like it\'s in good condition.
These valves are notorious for going bad, even more
so than the ignition coilpacks! They dont cause any
decrease in performance, but it usually decreases gas mileage,
and it will cause it to fail emissions testing. But worst of all, it
makes that MIL light on the dash flash...
It\'ll cost ya about $60 from the dealer.. have yer VIN ready..
there are 2 different ones for this generation: 1 with a nipple
and o-ring, the other with no nipple (requires separate o-ring).
Part #\'s: 14935-54u04 OR 14935-54u06
Read more:
http://engine-codes.com/p1448_nissan.html#ixzz3NjHQry7vRead more:
http://engine-codes.com/p1448_nissan.html#ixzz3NjHJadBZRead more:
http://engine-codes.com/p0732_nissan.html#ixzz3NjGYINs7
×