Question about 2000 Ford Windstar
It has a sentinel than minds the lights so you can exit safely, in the dark. Check the settings for lighting as they may have gotten thrown off. It is normal for the lights to come on after you remove the key, but they are on a timer and should extinguish within a minute or two.
Posted on Dec 12, 2017
Open the driver door and check the wiring between the driver door and the body (inside the rubber protector) which leads to the fuse box. It may be old and brittle or just broken. Re solder the wire and protect with electrical tape if broken.
Posted on Dec 12, 2017
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
If I recall the wiring plugs in at the top you may be able to pull the plug with out droping the back of the headliner, But I am not sure, if not pull the two clips in the rear and one uper side panel for access. You will need someone to help yu remove the door. After you get the wiring loose at the roof and the washer hose, remove one nut/bolt out of each hinge at the door frame, and loosen the other two, remove the gas lift shocks by using a small screw driver to pry the clip back on the end that attaches to the door while some holds the door up, then remove the last two bolt/nuts in the door hinges, and remove the door. If you need to use parts on the old door like the lock cylinder yoou will need to remove the inner plastic panel to gain access to the clip that holds the cylinder. Replace in reverse order and adjust to fit properly before tightning the bolts at the hinges, then snap lift shocks back on and replug harness at roof and washer hose. Hope this helps.
Posted on Dec 29, 2008
This means that your key is not being recogonized.Ethier the chip in the key is bad or the patts transciever at the lock cylinder. Do you have a spare key? If not you will have to get 2 new keyss cut and programmed.
Posted on Feb 16, 2009
one reason for that fuse to blow is a bad brake pressure switch on the master cylinder. could be a
warranty/recall item. can also leak brake fluid. also check behind each wheel for any sign of brake fluid,
particularly the rear wheels if you have rear drum brakes. fixed one here recently where the vehicle's jack
came loose in the right rear compartment and short that circuit. make sure your jack is stowed properly.
Posted on Jun 17, 2009
Tips for a great answer:
Nov 30, 2014 | 1998 Ford Expedition
Nov 26, 2013 | 2003 Ford Windstar
Mar 21, 2012 | 2000 Ford Windstar
Mar 20, 2012 | 2000 Ford Windstar
Mar 17, 2011 | 2000 Ford Windstar
Mar 11, 2011 | 2000 Ford Windstar
Sep 03, 2009 | 2000 Ford Windstar
Feb 15, 2009 | 2000 Ford Windstar
159 people viewed this question
Usually answered in minutes!