2009 dodge avenger just purchsed and notice that when daytime running lights are on if you turn on signal light that particular light will go off and when the signal is turned off the light comes back on.......Is this correct
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Probably a Cranckshaft or Camshaft sensor going bad when hot.
I haven't seen this particular isues in the Avengers yet myself, but if the ECT light is on with the engine light right before it stalls, I don't know of any other sensors that both Moduals read that could cause that.
To diagnose you will have to recreate the problem and then test the sensors to see what one is failing.
Provided the codes in both computers point you to one of those sensors.
check for a ground issue, if all grounds are secure and not corroded your issue will be in the switch, a bad ground can cause a lot of things to go out of whack.
Just because the bulbs look fine, doesn't mean they are. Start with the bulb replacement. If this doesn't solve it, and it has under 36K, it should still be under factory warranty. Shouldn't cost anywhere near $200 either way.
on a 2001 you would have to go to the dealer and have them program your computer, If you live in Canada, they will not turn them off for you. Charge is 65 bucks I think. Other than that there isnt much you can do at home, they run off a computer , when you turn right or left, you'll notice the light goes off on the side your signalling
replace the turn signal switch it self, mine did the same thing with the left turn signal, put in fuse and it will continue to flash... went to junk yard pulled one out of a 97 avenger just like mine, swapped them out and now it works fine. looked to be like some corrosion... to repace: 3 screws under columb, 2 screws on side of signal switch (black plastic side). unplug and replace
i also have a 2008 avenger rt.its o good thing your car is under warranty it is must likely the turn multifunction switch.which controls a lot of stuff light turn signals brights. i hope this helped please rate this answer thanks.
This is normal operation. The DTRL's turn off so on coming traffic can see your directional lights blinking. Your daytime running lights are so bright it is hard to see your turn signals during the day.
Also did you know that if you press in/out your dome override switch 3 times you can turn off your daytime running lights. After you hear a "ding" your lights should be off. Do the same to turn them back on.
I had the "service vehicle soon" light come twice with in 1 year. First the heald light bulbs were gone. Replaced the head light bulbs and after 2 starts the "service vehicle soon" light was gone.
The second time the DRL - #194 amber bulbs were gone. Replaced these and the "service vehicle soon" light was gone after 2 starts. The DRLs are housed in the headlamp housing, the tiny bulbs beside the head light.
×