1993 plymouth sundance transaxle vibrations when starting out at every stop. When ever I start out in drive, whether I just started the car or at a stop sign, there is a noticeable vibration. Then it goes away after the transaxle shifts into the next level.

I had a similar problem in my BMW. It turned out to be a bad drive shaft U-Joint.
Of course if your car is not a rear wheel drive, it probably isn't that.
Hope this helps

When you turn the ignition on the pump is energized for 2 to 3 seconds. did you check it like that. it is also energized when cranking the engine. there is a fuse then a relay then the fuel pump. the relay is ran/ energized by the ecm computer. if there is a fuse relay box under the hood you'll need to check there to. good luck

Did you replaced your whole distributor or just the cap and the rotor? Have you check the pressure on you fuel line it could be your fuel pump.

if this has been going on for awhile and getting worse it will be the ignition coils or the ignition module possibly

Hi I am vortash to check if the cylinders are getting fuel just turn the vehicles engine few times then remove a spark plug to see it it is wet if it is not a fuel problem more likely spark failure replace plugs as they can fail under pressure and check for spark ,, may als be a head gasket problem so check compression and see if above 140 0r in the green with each cylinder . hope this helps regards vortash

Make sure battery is fully charged. Connect a test light to battery ground and touch batt+ to check if light. Now test that there is power to the starter heavy wire directly connected to the starter. If power, good. Now test for cranking power to solenoid wire which is on top of starter; have someone cranks as you check for power. If there is power, starter could be acting up. If not, check all fuses and neutral switch. Be careful working around moving and hot parts.

Check battery terminals are clean and tight.Then check ground from battery to engine making sure they are clean and tight.

the ing. switch brake on these models replace the switch

ecu fuse or crank sensor , or cam sensor if it has one .

You need a timing belt