Can you put a size p215/65/15 on a 2004 dodge stratus es sedan

Here's an article that may be helpful. Not sure of the bolt size, I'd just put a few sockets on and see what fits best.
https://itstillruns.com/instructions-replace-thermostat-dodge-stratus-6720842.html

Check this link out. Replace Fuse 2001 2006 Dodge Stratus 2002 Dodge Stratus ES 2 7L V6

above the clutch housing on the top there is a flat part the number is stamped there. code should say bank 1 or 2 with the code. https://www.autozone.com/powertrain/engine/dodge/stratus/2005

Dodge likes to put the battery down in the drivers side fender well. In front of the tire, behind an access panel.

Should be as "simple" as putting a wooden block under the oil pan and slightly jacking up the engine, to releave weight from the mounts. Then remove bolts and remove the mount.

In my 2001 Dodge Stratus ES sedan (2.7L V6), the EGR has shiny piping that runs into the side of the black plastic intake manifold on top of the engine. The other end runs down beside the engine heads and routes into the rear exhaust manifold.

Hope this helps. Best of luck. 

What size engine. You want to know how to remove the crankshaft pulley right?

2004 Dodge Stratus Sedan
2.7 liter DOHC V-6 VIN "R"

HI. There are several other types you can fit into the engine compartment. I will list them below.

* 4 Cylinders 2.4L SFI DOHC
* 4 Cylinders 2.4L SFI SOHC
* 4 Cylinders 2.4L SFI SOHC
* 4 Cylinders 2.4L SFI DOHC
* 6 Cylinders 3.0L SFI SOHC

The drain plug is on the oil pan, bottom of engine. Use an adjustable wrench