Chrysler lebaron 1993

There should be a bolt to the wiper linkage that needs to be removed then their will be a few bolts holding the motor to the firewall remove these and disconnect any electrical connections.

try locking than unlocking passenger side door.

part store can print out 1993 chrysler lebaron engine belt

My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.

I do not know if you still need this information, but I am going ahead and answering it anyway. You may want to Print the Diagrams for future use.

CLICK on the following LINK. It has the Belt Diagrams you will need.
If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
Again my apologies...
http://www.2carpros.com/car_repair_information/year/1993/make/chrysler/model/lebaron/1993_chrysler_lebaron_drive_belt_routing_diagram.htm

Under the dash you should find the fuses for the system. They won't be in the fuse box. You are looking for wires that are wrapped in electrical tape. The fuse holders should be hanging somewhere around the bottom of the column or near the left kick panel. Remove the fuses to disable the system. Now after you have done this you need to find the added in relay for the starter disable. This should be hanging around down there too in the same area. Two of the wires from the relay should go in to the column or splice into the wiring going to the ignition switch in the column. Hook these two wires together and then you should be able to start the car.

the first thing u need to do is loosen bolts on the alternator then pull off the belt put the new one on and then tighten and pull up on the alternator /Thanks for using fix ya Please rate my response thank you very much

Hi Seems to be fine now thanks and I have a 1993 chrysler lebaron

all alarms have a switch to disable them the unit under the hood should have a place to insert a key to turn it off it will be a small funney shapped key if u dont have it then u need a electrican to remove it if it is a non factory alarm it is not hard if it is then auto electrian job if u need anymore help just ask

If it is the factory theft system then try shutting all doors and lock and unlock driver door with key. If has keyless remote, locking and unlocking with the push button should disarm.

I had problems with an alarm. the ground wire was loose. i deactivated it by disconecting the ground wire. when i repaired the ground connection. it worked well.