SOURCE: Hyundai excel 96. Bonnet Cable broken
difficult one but not surmountable,need right tools to remove grille and find a way into bottom of catch ,suggest you call your local mobile mechanic as this sort of thing is hands on and without car in front of me its difficult to advise as iam a general mechanic with a bad case of old timers.but most likely cause is the outer cable has pulled through the end fastening but what end ?? as i wrote its a hands on job.
SOURCE: The lighter and dash lights on our jeep grand
u can use wire prob and tap back of fuses on metal contacts and whe it doesn't like on both side it is blown pull and replace
SOURCE: dash board cluster lights are out 94 jeep grand cherokee
The sensor is located in the very front on top of engine slightly to the right, If you open the hood and lean over the engine just so you can see through the gap between the fan and the engine you will see two rubber radatior hoses kinda to the left then you will see the sensor to the right of them ,kinda looks like a spark plug with a plastic plug on the end of it with two wires connected to it.It screws into the ingine.
Testimonial: "thank you, very helpful"
SOURCE: 2001 jeep grand cherokee 4.0 . dash stops working
sounds like my 2000 let me know if you figure it out
SOURCE: My blower runs on high for awhile but only works
It sounds like you have two issues.
The fan only runs on high because you have a bad resistor for the fan motor. ( the high speed is the only speed that doesn't run through the resistor.
I believe you also have a bad fan speed switch.
I hope this helps you.
124 views
Usually answered in minutes!
×