P0335 Crankshaft position sensor location - honda civic 2008

The Crankshaft Position Sensor for the 2.3L 4-Cyl. engine is located behind the crankshaft pulley on the oil pump assembly.



DTC P0335 How To Change Honda Accord Crankshaft Position Sensor

see the diagram and videos I found for you. The fir5st one gives a brief overview and removal instructions




2007 Honda Civic Camshaft Crankshaft Position Sensors Location 2010 honda accord camshaft position sensor Google Search Repair Guides Electronic Engine Controls Camshaft Position Sensor AutoZone...

Here is a link to a page simular. DTC P0335 How To Change Honda Accord Crankshaft Position Sensor also you can ask auto parts store, they can help sometimes. Go on ebay an search part, many times the pic where it goes an part shown is there

The crankshaft position sensor on 1995 Honda Civic is located in the distributor assembly.

is it a no crank or crank no start?
Possible causes for code P0335
- Faulty crankshaft position sensor
- Crankshaft position sensor harness is open or shorted
- Crankshaft position sensor circuit poor electrical connection
- Signal plate may be damage
- Starter motor may be faulty
- Starting system circuit
- Dead or weak battery

Read more: http://engine-codes.com/p0335.html#ixzz3Cxw6SN6O

Ok! Both codes have to do with the Crankshaft position sensor. The P0335 means that you should replace the sensor, the 2a94 tells the pcm what code to display for the problem. Here is somthing you can do to make sure the sensor is really bad: If you unplug (or lose power to) your PROcede while the car is running. Or tried starting it while it wasn't plugged in fully, you will throw that code. Just clear it and see if it comes back. If it reoccurs while the car is driving, then you might have a bad Crankshaft position sensor.

P0315 - Crankshaft Position System Variation Not Learned
P0335 - Magnetic Crankshaft Position Sensor Electrical Error China OBD2 car diagnostic tools wholesale on CareUCar

P0335 - Crankshaft Position Sensor 'A' Circuit Malfunction

Possible causes- Faulty crankshaft position sensor (most common)
- Crankshaft position sensor harness is open or shorted
- Crankshaft position sensor circuit poor electrical connection
- Signal plate may be damage
- Starter motor may be faulty
- Starting system circuit
- Dead or weak battery causing slow engine crank over.

Diagnostic Trouble Code (DTC) P0335

Magnetic Crankshaft Position Sensor Electrical Error

In this circuit DTC (data trouble code) sets when

a) The magnetic crankshaft position sensor is > 0.2V.

Or when

b) The minimum value of magnetic crankshaft position sensor is

Or when

c) The maximum value of magnetic crankshaft position sensor is higher than 2.2V.

In the kit there are two sensor that look identical. The one for the crankshaft has a white paint mark on it near the bolt hole. Make sure that it is in the right location.