I want to upgrade the speakers by the back window but want to know how to remove the carpet to get to the speakers.

• Enclosed subwoofer with dual 12-inch speakers; measures 27.5 x 14 x 15 inches
• illumiNITE technology constantly illuminates the speakers with blue LED lights when in use
• Handles 600 watts RMS power, 1100 watts peak power
• Carpeted enclosure, plexi subwoofer viewing window
• Dual 12-inch Low-Q optimized dri

see the carpet under the back glass that has to come out. you will need to remove the brake light at the back glassd

1Lift the rear seat all the way up and towards the front of the vehicle.

2Remove the five Phillips screws holding the scuff plate at the rear opening of the vehicle. Remove the scuff plate.

3Use a panel tool to pry off two screw covers on the edge of the headliner in the cargo area. Remove the Phillips screws located behind each of the covers.

4Pull the carpet away from the edges of the rear-side panel. Remove four Phillips screws located below the carpet at the bottom of the rear-side panel. Remove the two Phillips screws holding the cargo cover hooks located on the rear-side panel.

5Pry around the bottom and back edges of the rear-side panel and pull the panel out far enough to access the speaker.

6Remove four Phillips screws from the edge of the speaker with a Phillips screwdriver. Pull the speaker out of the door and unplug the wiring harness connected to the back.

New molded replacement carpet, should not require cutting, yes the console will need to be removed, seats too, everything that is above the carpet from side to side and front to back should be removed, then install the new carpet, and re-install everything you took out. Hope this helps, let me know.

Most of the rear window speakers mount from the underside in the trunk.
Check there to see if you can unhook and remove the speakers from the trunk side before tearing up the interior covering.

Go from inside the trunk and access speakers and disconnect wiring. You can also pry out the carpet above rear seats. Make sure there are no clips on bottom. There will be 4 screws for each speaker that will need to be removed. For front speakers, you will need to remove all screws in door panel, including window and lock and mirror controls. Then With big flat-head screwdriver and gently pry directly next to plastic studs holding panel on. You should have 4 screws holding on that speaker.

Navigation is in the trunk.
Remove carpet. Open part of trunk closer to back seat.
you will see plastic container containing tools, jack.
On the right side, there is a small cover with two notches.
Press them down, and pull the cover forward.
It will come out and reveal the DVD drive.
Put key in ignition switch to remove DVD and insert new one.

If it is the factory installed speakers.They are come out thru the inside.You need to remove the rear deck carpet...Easiest way is to remove both back seats first .
Remove the bottom seat first by pushing the seat towards the back of the car / then lift it up.
Then you will release the other seat by (using a socket set) to remove 2 nuts inside the trunk.then the seat will be release to simply lift out of the car. remove the top deck carpet .
The speakers are held in by 4 angled clips.
From inside the trunk, release the 4 angled clips,disconnect the speaker wires.Then push the speaker inside the car and your done. Hope this helps.

The rear speakers you need to take at least one side off. What I mean is the part when your sitting in the back seat the plastic piece were the armrest is. After you take at least one or both of these out just fold the seats down and the rear window carpet piece will have four plastic push pins then just pull it straight back and its out. After the carpet is out just unclip the speaker and pop it out then unplug the harness.

The front first you need to take the screw out of the small piece up by the side mirror and pull that piece out, then pull the metal clips for the window cranks, if you have manual windows. then the screws in the grab handles, the rest is just plastic clips. Just either get a specialty tool for this or I use a butter knife and slowly pry the door panel up and work it around the entir panel until its loose. sometimes no matter how hard you try to be carefull the clips will break though. They are failry cheap if they do and autozone should have them. after the panel is off it is pretty simple just take out the screws holding the speaker and pop it out then unplug the harness.

on both side behind the rear speakers, if u unbolt the speakers there is enough space that you can fit your arm through and make it poke out in the trunk....and in the trunk you just remove the carpet to get through, you can out that back when your done