-
Expert
75 Answers
- Posted on Oct 21, 2010
Re: Where do I find a diagram to change the power...
REMOVAL
- Disconnect negative battery cable.
- Remove sight shield.
- Remove module bracket.
- Disconnect No. 6 spark plug wire to prevent damage to wire.
- Remove radiator fan shroud assembly.
- Remove top RH isolated radiator mount bracket.
- Remove remote air cleaner.
- Remove ignition coil.
- Disconnect electrical connector on power steering pressure switch at steering gear.
- Remove pressure switch to allow for tool clearance.
- Remove screw at pressure switch and return line bracket.
- Remove anti rattle clips from power steering lines.
- Remove plastic strap attaching steering gear heat shield to power steering return line.
- Remove plastic strap attaching lines to transfer tube on the steering gear.
- Disconnect Electronic Vacuum Regulator (EVR) valve wire.
- Remove the ground wire from back of engine block.
- Remove pressure line fitting at power steering pump using a 5/8 inch flare nut wrench.
- Loosen clamp and remove return line at pump.
- Loosen clamps and remove return line at power steering oil cooler.
- Remove pressure line fitting (gold in color) at steering gear, using an 18mm open end wrench.
- Remove return line fitting (silver in color) at steering gear, using an 18mm open end wrench.
- Loosen two screws retaining power steering oil cooler to sub frame.
×