How do you replace the ignition key switch for a '96 chevy diesel 1 ton 4wd pickup truck?

Ignition Switch Removal & Installation To Remove:

1. Remove the steering column trim covers.
2. Remove the wire harness from the retainers as needed.
3. Slide the 2 connectors of the multifunction switch assembly out from the bulk head connector.
4. Detach the key alarm connector from the lock assembly.
5. Remove the ignition switch mounting screws and the ignition switch from the steering column.

1. Install the ignition switch on the lock module.
   • Tighten the screws to 42 lb in (4.7 Nm).
2. Install the key alarm connector on the lock module.
3. Slide the turn signal and multifunction switch connectors into the bulkhead connector.
4. Install the harness in the original retainers.
5. Install the steering column trim covers.

1. Disconnect the negative cable from the battery.
2. Disable the supplemental inflatable restraint (SIR) system.
3. Remove the steering column trim covers.
4. Turn the ignition lock cylinder to the run position.
5. Using an awl with a bent tip, insert the tip into the access hole of the ignition lock cylinder.
6. Turn the lock cylinder to start and push down and hold the lock cylinder retaining pin.
7. Release the lock cylinder to the run position and withdraw the cylinder from the steering column.

1. Align the slot in the steering column to the tab on the lock cylinder and install the lock cylinder until it locks in place.
2. Install the steering column trim covers
3. Connect the negative cable to the battery
4. Check for correct operation