No, that code is for crank sensor:
Engine RPM input - circuit malfunction
Possible Causes: Wiring, CKP/RPM sensor, ECM/TCM
CODE PO725 A/T ENGINE SPEED SENSOR CIRCUIT MALFUNCTION.YOU NEED CODE ERASED AFTER REPLACING THE CRANKSHAFT SENSOR.IF CODE PO725 STILL REMAINING.YOU HAVE WIRE FAULT ELECTRICAL CONNECTOR OR FAUTY PCM.
Hello! No, it's the Vehicle Speed Sensor (VSS)...Send the year, model, and engine size and I'll be more specific...Guru..Saailer
I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867
DTC P0725 - ENGINE SPEED SENSOR CIRCUIT
When Monitored: Continuously after a ignition key is turned from the OFF to RUN
position and/or key is turned from the CRANK to the RUN position.
Set Condition: The code is set when the engine speed sensed by the Transmission Control
Module (TCM) is different than the engine speed reported by the Powertrain Control
Module (PCM) over the Communication Buss.
POSSIBLE CAUSES:
CHECKING SYMPTOMS AND POSSIBLE CAUSES
LOW BATTERY VOLTAGE
BAD CONNECTIONS AT VARIOUS CONNECTORS
CRANK POSITION SENSOR SIGNAL OPEN
CRANKSHAFT POSITION SENSOR GROUND CIRCUIT OPEN
TCM CRANK POSITION SENSOR MONITORING DEFECTIVE
Hope this helps.
946 views
Usually answered in minutes!
×