How to remove ignition switch from 75 cordoba

somewhere around 60,000 miles to be on the safe side

Try Lucas no slip up to three bottles.remove difference.

either fit battery cut off switch or try taking the wires off the back of the alternator ,i have a funny feeling its a diode packed up in the rectifier

It is 1-5-3-6-2-4. #1 is at the front of the engine and the distributor turns clockwise. On the distributor #1 is at 5:o'clock looking from the passenger side, or the first hole past the clip at 5 o'clock. Hope this helps.

the wiper motor should be under the dashbord

sounds like stuck pins

insert key tap the end of key with malet untill it turns
once it turns drive to lock smith have them remove and repair the ignition cost will be 50 - 75 bucks verses dealer at 200 bucks

No we have not found a solution, as our car is a SEAT Cordoba, not JETTE, because you dont have SEAT Cordoba on your list of cars, possibly because your website is US based, and you dont have SEAT,s in the US

hello
you will need to change the carb
distributer
ecu
small wireing to do
here a link for a distributer and wiring kit
carb can come from a salvage yard or ebay
you will need a pre 79 318 carb
http://cgi.ebay.com/ebaymotors/318-340-360--Mopar-Electronic-Ignition-Distributor-Kit-_W0QQitemZ120361032495QQcmdZViewItemQQimsxZ20090109?IMSfp=TL090109112004r30670

http://cgi.ebay.com/ebaymotors/Carter-8233S-1979-81-Dodge-Plymouth-318-Carburetor-Carb_W0QQitemZ290185721078QQcmdZViewItemQQptZMotors_Car_Truck_Parts_Accessories?_trksid=p4506.m20.l1116

I have done this with my '79, so yes it will work. Although my car is a 360 four barrel, the external engine size is identical. The black box on the stock air cleaner is the "Electronic Spark Advance" computer. It replaced the more well known "Lean Burn" as the ignition/fuel management system. Since you will be disconnecting and discarding the ESA due to the air cleaner change, another ignition system must be installed to replace it - if someone has not already done so. I used a Mopar Performance electronic ignition system-still available for about 200.00. This will not hurt anything. The chrome valve covers fit right on. However on my car, the vacuum amplifier bracket was attached to the right side value cover which I cut off the stock cover and screwed into the chrome cover. I sealed the screw holes with gasket sealer. I do not know exactly what you are referring to regarding the cover connecting the value cleaner to the crankcase breather. There is a hose from the breather which connects to a fitting on the air cleaner. This hose allows the crankcase to vent into the carburetor during wide open throttle conditions when the engine vacuum-operated PCV cannot function. I do like the chrome effect even if it does require more care and maintenance. Good luck!