How to program "Welcome ligths" on bmw e60 2004?

ENGINE CONTROL MODULE (ECM) INTERNAL CIRCUIT MALFUNCTION

Engine Control Module (ECM) internal ROM, RAM, A/D converter function

Thanks for choosing FixYa and welcome. This means you need to change the first 02 sensor. This is the closest one to the front of the engine.

Hi There, Not to worrry, this usually occurs when the car is old as long as you ensure your brake pads are well fixed, you can ignore this and continue driving. Just ensure your breakpads have been newly changed.
Cheers.

If you log onto this site, it can provide a free download of the original manual, which would show all dash symbols and what they mean. Good luck, Curt
https://www.bmwusa.com/Secured/Content/Forms/Login.aspx

switch off ignition
press & hold button between speedo and fuel gage
turn ignition to pos I
after 5 seconds the word "oil service"or "inspection"are shown together with the message "reset"or "re"
release button on dash
press and hold button - after 5 sec the message "reset" starts to flash
release button - press and release button again
the new service interval is now displayed
press and release button
the message "end sia"is now displayed
switch off ignition

Hi miguel_mitie, the reverse light switch is on the right hand side of the gear box and has a square 2 pin connector, it may also be worth checking the wriring in the rear harness by the boot lid hinges as the wires have been known to break

my service engine ligth came on then it went of

BMW insp. reset -Ingnition OFF (pos 0)
-Press and Hold the trip odometer button while turning key to position 1 (accessory)
-Keep the button depressed (about 5 secs.) imto; upi see "Oil Service" or "Inspeciton" with "Reset" or "Re" in the display
-*Note: ON vehicles with "High" cluster, you will also see the amount of fuel (in litres) remaining until next service
-Press the button again and hold for approx. 5 secs. imto; :Reset" or "Re flashes
-While the display is flashing, briefly press the button again to reset the Service Interval. After the display has shown the new interval you should see "END SIA" for about 2 secs.
Note that if the "Reset" or "Re" does not flash, then you have not met the minimum consumption level and cannot reset.
2001 up to 2003 for shure don't know about any other models, where i found this it said 2001 to current but not shure when it was posted. Thanks

ZOOM